depends on model...sometimes the front/top is removed by pressing in on hidden tabs between the top and sides. (can use a dull table/butter knife) Others are removed by separating rear and all sides/top. Check inbetween sides/top by looking/pushing tub aside to see inside top/sides. If you see screws holding them together, then it is a rear/top-sides separated model.
Begin with screws on back of controls, and two in front. Then remove all screws on back, including the water inlets and outlets. Back should be loose. Controls lift up, disconnect lid switch connection, back lifts up an inch or so, and they separate. Frame holds motor and basket, wiring is laced onto back with clips, move end of clips to open.
Wash-o-Bubz
March 2009
We need to know too. We are in the midst of trying to take the back off and we have been unsuccessful. Have you gotten that far?
Tara
March 2009
Automatic Answer
While you wait for answers, we may have found some information which could help you.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix washing machines.