How to mend ... Where Two Screws

How can I fix my Hoover ab130?

The door of my Hoover AB130 has been very difficult (now impossible) to open after a wash. Pressing the butto... [Read more]

ryobi carb adjustment?

Model 720r hard starts, then dies within 10 seconds. It is used, and holes are drilled in case to access car... [Read more]

How do I stop a cassette from squealing?

The tape plays well, and the speed is proper, but it squeals. I've taken out the screws and oiled the only th... [Read more]

Oil Leak in Kitchenaide Artisan Mixer - Remove Chrome Ring?

I need to repair an oil leak in a Kitchenaide 5 Qt Artisan Mixer. I have the correct grease and have removed ... [Read more]

DC07 still cutting out???? Help?

OK, I've cleaned all through my DC07(Purple & Green one), undone the screws on the top and washed through the ... [Read more]

hotpoint sidebyside refg. ice door model HHSS22IFMAWW?

Iask about this before now I have found out that it is called the ice door. I have found parts like new door, ... [Read more]

how to remove an aerial fixture from peugot 106 roof?

my aerial block on the roof is not working correctly and the rod is floppy, I want to change the u/s rubber bl... [Read more]

how to remove a water pump from a 1984 1994 opel kadett (vauxhall astra)?

I need to take off the old water pump of my opel kadett, I have removed timing belt and gears also three retai... [Read more]

How do I reach drain on Kenmore refrigerator?

I have a Kenmore 363.9634719 refrigerator. Water pours down the back inside wall and also drips from ceiling ... [Read more]

My Fellowes CC-4 paper shredder?

With the switch in the shred position, it will not shred paper, but will run in reverse when the switch is put... [Read more]

How can I fix my electrolux contour 1000W?

How can I get to the switch on above I have removed the thre obvius screws but the cover will still not come a... [Read more]

how can i fix my dyson?

I can't get the unit open to get to the motor. i have removed 2 screws but there must be another one that i c... [Read more]

How do I take apart a Rowenta DE-871 steam iron?

The top section has come loose at the pointed end, and now feels unsafe to use, though the iron still works. T... [Read more]

Indesit D63. How can I gain access to the door internals?

I have an Indesit D63 which i beleive has a failed timer/programmer. I have sourced a replacement timer but I... [Read more]

Whi tool do I need to open the casing of a Polti Inox 5000R?

I have a Polti Inox 5000R which needs a new flex but the heads of the screws which hold the tank casing toghet... [Read more]

How to expose engine for cleaning on Electrolux EPIC model 6000 SR?

I need to buy a replacement sensor for my bag lockout sensor switch. It's a round plastic piece and the base ... [Read more]

how to remove electric motor on Electrolux model 6500 canister vacuum clean?

The electrolux EPIC6500 SR canister vacuum cleaner has no external screws. The parts are held in place by the... [Read more]

97 Tahoe?

I need to replace two interoir cast aluminum door handles and can remove the door pannel up to the point where... [Read more]

How to remove covers on a Creda 37317 tumbledrier?

I need to get at the drive belt on a Creda 37317 tumbledrier. I have removed all the screws I can see, but it ... [Read more]

My trimmer won't run McCulloch MT270?

Hi, I started finding this strimmer difficult to sart and would not run at full throttle, as if the choke was... [Read more]