How to mend ... Still After Replaced

t90si motor brushes?

removed the motor from the pump housing and replaced brushes. When I refit the motor into the pump housing and... [Read more]

iveco 2.8 turbo 1998 electrical problem?

Hi there i have a 1998 iveco2.8 turbo van which when i tried to start the other day the electrics completely ... [Read more]

How can I replace the diaphragm on a Jetflow syphon?

Having removed the syphon and finding the diaphragm damaged I could not fit a replacement item since removal ... [Read more]

Hotpoint Aquarius DWF40P poss needs new 'programmer'?

Can anyone help? I've got the above dishwasher, been hardly used but has developed a fault and stopped working... [Read more]

eurocal boiler oil, radiators constantley on when no heating on. ?

the radiators upstairs are always hot, no heating is on and the boiler fires up when nothing is turned on such... [Read more]

Replaced the battery, still flashing exclamation point?

I replaced the battery, the alarm worked for about 32 hours while the exclamation point continued to flash. T... [Read more]

card key problem?

my card key wont open or close doors. i have recently replaced battery , what can i do ?

to adam the bike doctor?

help please. i have a sukida ( i know never again). the electrics are broken. i replaced the ignition barrel, ... [Read more]

I have a Craftsman Lt 2000 it runs and then dies, how can i fix it?

I have a Craftsmen LT 2000 ( Briggs and stratton intek 18 ohv engine) Its turns over and runs good but after a... [Read more]

I replaced the hall sensor, but my LG WM0532HW still showed LE error code?

I have a 2004 LG WM0532HW washer having LE error problem. I searched the web and replaced the hall sensor as ... [Read more]

Stoves 720ef not getting hot enough?

I have aquired a Stoves 720ef which had what we thought was a thermostat issue, but also had a stoves single o... [Read more]

Smeg fan oven, fan working but no thermostat light and no heat?

Smeg fan oven model no SE335SS-5,strange burning smell for last few times of use, then switched it on and the ... [Read more]

Replaced heating element - still no heat! Zanussi TC484W tumble dryer?

Please help - my tumble dryer was spinning but not drying with heat & following advice, I replaced the heating... [Read more]

Dishwasher continuously runs but is stopping in cycle?

Frigidaire UQ2, Model FDB740RCB0. 1) Timer is replaced... cost 150.00 (I'm mad). Old timer was fine but pa... [Read more]

triton amber III shower cycling hot/cold?

i have a triton amber III shower which is cycling hot/cold on the high setting but not on the economy setting.... [Read more]

peugeot 406 key coding ?

i have replaced the key on my 1999 1.9 turbo d 406 to i need to get it coded to start the car or can i by pas... [Read more]

How to fix my John Lewis washing machine JLWM1202?

When a wash had finished I went to switch off the machine with the dial but the lights started flashing and th... [Read more]

I have a jaguar 28 boiler?

the large digital disolay has blown a fuse, replaced it but the board has now blown. Any idea how much for a ... [Read more]

snapper leaking gas?

I have a briggs 6 hp engine, that leaks gas down the back side of the air filter. I've replaced the gasket bet... [Read more]

WF321 Heater Relay?

I have just replaced PCB from EMW, but lights still flashing. Light 1 (wash enhance) + On/Off - which sugge... [Read more]