How to mend Pcb If Could Pcb

2

Glow Worm Ultimate PCB Fault...Resistor colours needed?

Hi, I have a Glow Worm Ultimate 40FF which has Stopped...it's quite obvious from the PCB what the fault is: ... [Read more]

1

Beko won't spin and empty water?

I have a Beko WMA 520 s and as i've said above it won't spin and empty water. It will do the wash cycle right... [Read more]

2

Sharp Microwave oven R-953 Timer is faulty. how do I fix it?

When I start the oven it counts down just 59 seconds and then goes to stand-by. Pressing the start again will ... [Read more]

2

AEG LAVAMAT TURBO 16800?

Hi I wonder if anyone could tell me where I might be able to get a pcb for an AEG Oko Lavamat Turbo 16800 was... [Read more]

2

Hoover HNF7167 water not emptying. I first thought it was pump, but?

Hoover HNF7167 water not emptying. I first thought it was pump, but tested it and it works. Put it back on and... [Read more]

7

Potterton 50e fan cycled, changed the pcb, now nothing?

My CH fan was running but it was not firing up, kept cycling for over 40 minutes before starting up and heatin... [Read more]

2

Glowworm Spacesaver KFB 60 cuts off after hot water?

Bought house 1 yr ago, had a problem with the boiler since day 1. The problem is that the boiler cuts out afte... [Read more]

2

Glowworm Spacesaver KFB 60 cuts off after hot water?

Bought house 1 yr ago, had a problem with the boiler since day 1. The problem is that the boiler cuts out aft... [Read more]

2

E40/E41 error code on Zanussi IZ16s NOT door solenoid?

Hey, I wondered if someone could point me in the right direction. I've done some searching on the forums to fi... [Read more]

3

Myson Midas sfi?

Does anyone have a Myson Midas Sfi lying around? I'm looking for the main PCB board but would like any other p... [Read more]

6

HELP WITH MYSON HOUSEWARMER?

Need some help with a Myson Housewarmer 55 electronic. No ignition. No manual. I am corgi registered and went ... [Read more]

2

Halstead Eden CBX 32 boiler fault?

Hi I got a Halstead Eden CBX 32 boiler about 2 years old, the heating is not switching on from the clock. ... [Read more]

1

indesit widl 126s washer/drier?

module brown up cost of new one £110 ! minus eprom what is an eprom anyway? how does indesit justify over ha... [Read more]

1

how to tell if my pcb is faulty?

changed my pcb two years ago becaase it kept locking out it is now happening again could it be the same proble... [Read more]

8

Ravenheat CSI 85T?

Hello, I've had a good look around this site and can't find an identical issue, so I'm hoping someone can h... [Read more]

2

Gas valve failing to open on ferroli domicompact f24b?

My boiler has been working fine, used it last night before bed with no problems or noises. Woke this morning ... [Read more]

2

how can i fix my glow worm 30 cxi?

Hi, I have a glow worm 30cxi boiler and have a problem that hopefully someone can help with. The problem... [Read more]

2

Glow worm ultimate 50ff fan comes on for 3 sec and go's off don't ignite?

If the pressure switch hose is disconnected the fan will run but with no ignition. Pressure switch checks out ... [Read more]

8

WORCESTER 28si II COMBI BOILER?

we have the above boiler ...when running a bath we noticed that after 3-4mins the water would run cold ..got a... [Read more]

3

hotpoint aquaris wt740 no power dead?

washer worked one day next day no power had a guy round whom seemed to think it was the pcb board but didnt re... [Read more]