How to mend ... Help Air Screw

Ford KA Heater Problem, Very hot Heater resister unit?

Help. I have replaced the Heater control valve, it works now i think... I swich the car on, and it moves the ... [Read more]

Megane 1.5 DCi on 52 Plate - No heat from in car heater?

Getting no heat from the in car heater. Have checked coolant and is set to good levels, have bled the coolant ... [Read more]

My 814 wont start !,i cant bleed air is there a bleed nipple to loosen off ?

do the 814's have a bleed screw to loosen before using the manual pump ?, the glass bowl fills with fuel whils... [Read more]

megane 1.5dci air bubbles in fuel lines,?

My megane 1.5dci is slightly lumpy for only a few seconds on start up, it then runs fine and picks up well, so... [Read more]

How do I stop my Kohler Command Engine from governor hunting at full throt?

I have aCV25 Spec.#69534 Kohler Command Engine I recently overhauled for a friend the engine starts instantly ... [Read more]

My bleed screw has broken off on my rad . how can i fix it?

I cant drain my rad of air because my bleeew screw has broken what can i do ????

pull start???

I have a blata 39cc midi quad. Its been stud for 1yr and the kids nagged me to get it going. I drained the tan... [Read more]

glow worm betacom 30 not firing?

I'm a carpenter and my mate decided to stick a screw thru the 28mm return pipe, I have repaired this and refil... [Read more]

baxi 105e?

I have a baxi 150e on top of the automatic air vent there is a small screw there is water coming out of the sc... [Read more]

unvented hot water central heating problem boiler potterson ?

boiler firing ok, watter silender ok but heat not comming to rads watterpump ok ( strong ) pipes hot around th... [Read more]

How do I get my 24A super colt to keep running?

My 24a sc runs for 3 seconds then dies and wont re-start. It used to run ok before I re- connected the tick-ov... [Read more]

how do i reset my mixtur screw back to orginal settngs on a piaggo zip 50 ?

i recently put a kandn air filter on my zip 50 then my freind mesed about with my mixture screw and it was bog... [Read more]

carb set up?

how do i set up my carb it seems to be getting too much petrol how many turns out do you turn the air screw ?

What are the carb adjustments for a STIHL 026?

I own a STIHL 026. I had it running, and then I touched the carb adjustments. I have left the H adjustment scr... [Read more]

how can i make my direct bikes ninja go faster/ deristrict it????

i have fitted a performance exhaust and there does not seem to be any restrictor in air box or a screw on the ... [Read more]

Appliance Repair Safety?

Appliance Repair Safety In servicing Appliance equipment, you must often expose Appliance components to obs... [Read more]

What is the initial air/fuel settings on Ryobi 725R?

I bought this trimmer at a garage sale cheap but I'm not sure if I still over paid!! What are the initial carb... [Read more]

McCullock Cabrio 310 Petrol Strimmer?

1) What is the Petrol / Oil Mix? 2) on the ZAMA carburettor - Which adjustment screw is for Slow Running ... [Read more]

Bosch Worcester 28i RSF Combi Boiler?

You help would be very much appreciated........I have noticed water dripping on to the floor underneath my boi... [Read more]

Appliance Repair Safety?

In servicing Appliance equipment, you must often expose Appliance components to observe the operation before y... [Read more]