How to mend ... Panel Control Help

Veritas R8 Plus?

Hello, I have a Veritas R8 Plus with 1 LCD control pad. We were woken this morning by the alarm going off,... [Read more]

veritas r8 control panel?

what do i do to prevent the siren from sounding when i access the control panel

veritas 8 keypad no power?

we have a Veritas 8 alarm, this morning it went off, I went to reset it but nothing worked, the light on the k... [Read more]

scantronic 9800 flashing rt fault code ?

very first fault code was b f at 6-30 a.m. replaced with a new battery, 2nd fault code was l t (control panel ... [Read more]

Veritas 8 alarm, cut through sensor (pir) wire - help?

Hi I was recently doing some DIY and removed a skirting board. Unbeknown to me inside it was the wire that l... [Read more]

how to fix it?

does each pir sensor need its own cable going to control panel

New Scantronic 9800 control panel?

My control panel works well but is looking dirty and worn. Can I get a compatible replacement?

where can i get operators instructions?

scantronic 9448+ dont know whatbutt0ns do on front of control panel

Have to move my Optima XM?

Will it be safe to take the power off at the fuse box and reposition the control panel a few inches away and t... [Read more]

veritas alarm?

main fuse went at local sub station and set my alarm of since then i have had problems with it the unset light... [Read more]

9600 scantronic?

I have a 9600 house alarm and the alarm keeps going off, the control panel reads kitchen tamper reset required... [Read more]

Optima compact Strobe light keeps flashing, no led's? ?

I've installed a brand new optima compact control box and AZ-1000 external sounder. Zone 1 entry/exit Magnet o... [Read more]

Itec horizon alarm panel?

With my limited knowledge, I put in engineers code 1191 to open control panel to change battery. This worked o... [Read more]

panic buttons veritas 8?

i have two panic buttons each with their own wiring. how can i connect them , to the control panel

How can i fix my Veritas R8 Alarm?

I have changed battery in above alarm, how do i get my zone sensors to detect when alarm is set.( No red light... [Read more]

Scantronic 9827 control panel?

Hi, I turned off my alarm and RT is now flashing with a light against fault, is there anything i can do to ... [Read more]

itec horizon alarm "C"?

Hi, a "C" is displayed on my ITEC HORIZON control panel. The user-manual says that "C' stands for "Engineer Re... [Read more]

No power to the key pad in Accenta 8?

Following a power cut in the area, the power to the key pad is no longer there although the power is ON in the... [Read more]

How can I fix my ADT system - loss of power?

My ADT system (made by Digital Security Corporation) goes off randomly. However, the control panel lights are... [Read more]

Accenta 6 Alarm System?

I've just replaced the remote keypad which was about 12 years old. I've also had to replace the fuse for the... [Read more]