How to mend ... Engineers Mode 8

how to exit instalation mode?

when i exit engineers mode i entered 99 tick exit engineer i then press tick and i get zone 08 open but this z... [Read more]

Optima XM 4 zone issue?

Hi all I installed my optima some twenty years ago now and have regulary serviced it up untill the present da... [Read more]

Accenta G4 mini and remote keypad only illuminating?

I recently had an issue with my Accenta G4 alarm and remote keypad. For some unknown reason the tampers were a... [Read more]

engineers mode accenta 8?

How do i put my accenta 8 into engineers mode

lockout?

accenta g4 panic attack button was activated by decorators & system has gone into lockout mode ,I have put the... [Read more]

do i need to enter engineers code to dis-connect external bell box and repl?

hello need some advice, have tested bell-box which has a supply present from alarm panel of 12v d.c,the o/s so... [Read more]

Could the NVM chip be dead after 13 years?

I put my system into engineers mode (0xxxx then opened panel, E displayed). This was to allow me to disconnect... [Read more]

Veritas R8 alarm query?

Hi, my alarm has been installed for 15 years and have had no problems. The installing company is now defunct. ... [Read more]

Itec horizon alarm panel?

With my limited knowledge, I put in engineers code 1191 to open control panel to change battery. This worked o... [Read more]

Optima accenta g3 system locked, panel shut down?

I was removing a PIR sensor from the wall when decorating and set the tamper off a few times whilst removing/r... [Read more]

veritas keypad in tamper mode cant reset system?

veritas keypad has been opened and repositioned but now in tamper mode cant reset or access system is there a ... [Read more]

Programming Veritas Alarm?

I have a veritas R8 and when I try to enter programming mode for bell test and the like I get a single tone an... [Read more]

Gardtec 300 - maintenace mode?

I need to turn the mains off for 30 mins or so but the alarm will of course go off for about 20 mins. Is there... [Read more]

accenta mini G3 , strbe keeps flashing?

I moved a PIR to decorate then came out of engineers mode since which the strobe has continued to flash (not a... [Read more]

optima xm: can i change zone configuration in engineers mode without activa?

Have recently inherited an Optima XM system but now wish to make changes to the programmed zone configuration ... [Read more]

Optima XM6?

my optima xm6 system was on a twelve month contract, but the engineer has now ceased to trade and will not att... [Read more]

How can I set an exit time?

The system is an Optima Plus Working fine until I removed the mains fuse, then unable to set an exit time. W... [Read more]