Mend > Chainsaws

how can i fix my mcculloch eager beaver 2.3ci?

i was given ths chainsaw its a mcculloch eager beaver 2.3 ci and noticed the fuel lines are all broken and ou... [Read more]

2

husqvarna oil pump?

Husqvarna 350.. Is there an adjuster on the oil pump to regulate oil feed. If so, where is it located?? ... [Read more]

1

my chainsaw won't accelerate from idle speed?

I have a spear & Jackson chainsaw 2.5 years old, it was running ok, then when I tried to use it again it would... [Read more]

power-craft chainsaw?

pc40-38cc sn-010405418. I've just pieced one back together for a friend, but what would be the carb settings... [Read more]

I have a stihl chainsaw 015L and have replaced the cord, but having an issu?

I have a stihl chainsaw 015L and I have replaced the cord, but having an issue with the installation of the tr... [Read more]

Electric chainsaw parts?

Where can I obtain a replace drive cog for a performance ( B / Q) electric chainsaw model YT 4653. thanks

I need a new nylon idle gear for a Gardenline electric chain saw ?

The nylon idle gear has stripped on my chain saw Gardenline electric chain saw model GCS 2000S. Any ideas wher... [Read more]

I have a Homelite trimmberman. that will not run right?

I have a Homelite timber man chainsaw it will only run in the choc position but it will not run right when you... [Read more]

mcculloch cs380 chainsaw?

No spark, How do I check the continuity on the Ignition coil, and what is the air gap for refitting. t... [Read more]

2

replacent chainsaw blade ?

What is the specification of a replacement saw blade for a sovereign elettra 160 chain saw and what is the cos... [Read more]

Power craft pressure jet wash 7944 ?

I am having problem with power craft jet wash when I start motaer run with1st stage after pressing water treeg... [Read more]

blowback thru carburetor from piston?

my 031 stihl chainsaw has air blowback from the piston back thru the carb. the exhaust ports and the muffler... [Read more]

echochain saw 16" 330?

how to change bar studs

Replacing Ryobi PCN4545 oil pump?

Hi, There are a lot of questions on here regarding the pcn4545 oil pump but none clearly explain how to get... [Read more]

1

How do I attach the throttle lind to the carberator?

Putting in a new tank to carb fuel line. Wire from trigger to carb came off at carb. Where do I route it, corr... [Read more]

Husqvarna 60?

Run sometime but run hot hard to start blow oil from sparkplug if its a lil loose

2

husqvarna 142?

Will not idle down can 't get the chain to stop spinning. have back idle screw out all the way.no change in r... [Read more]

how can i fix my ryoby pcn 4545?

pcn 4545 ryoby wont start not seized. spark at plug , compression seems ok. engine suddenly died whilste in ... [Read more]

?

How can one get a battery for parkside hand held garden shearer - no one seems to stock them any more - the mo... [Read more]

how can i fix chainsaw mac 335?

cleaned out tank.....starts....then stops....seems that brake might be slipping back on each time causing cut ... [Read more]