Mend > Grass Trimmers

information on my B n S 5 HP engine?

just aquired a templer professional 500 rotavator, the engine has two output shafts that rotate in counter dir... [Read more]

ryobi touch start trimmer switch wiring?

i need a diagram of the wiring for the start stop switch and battery start switch for my ryobi trimmer

how to replace stater pull cord?

I have a Ryobi petrol trimmer Rwt285ds... The pull cord needs replacing and I have got as far as the clutch a... [Read more]

update to handy muli tool..fault?

after consierable searching and no help from dealers? the problem seems to lie with a faulty plug cap. hop... [Read more]

how to tune a carb on a macalister mbcp 254 brushcutter?

i have been given a macalister mbcp 254 brushcutter i have replaced complete fuel line bung and priming bulb a... [Read more]

Whipper Snipper Top Bearing?

How do I replace the top bearing on my Komatsu Zenorh G20LS whipper snipper

The Handy multi tool, none starter ?

I understand that this item has a common fault, It has a spark and fuel? occasionally? does anyone know wh... [Read more]

Bosch ART 21 grass trimmer?

How do I dismantle the Bosch grass trimmer ART 21? I want to open the motor housing to see if power gets thro... [Read more]

how can i fix my ryobi RLT254FCDSN whipper snipper?

Whipper snipper makes loud rattling noise in the engine and vibrates excessively. Have recently replaced spark... [Read more]

Ryobi whipper snipper not working. ?

My ryobi whipper snipper is not starting. I've put a new carburetor and it is still not starting. I've only ha... [Read more]

How to stop the shaft from rotating?

I'm not sure if the detent unit has something to do with it,but the whole shaft turns 360 at will.There has to... [Read more]

how do i fix my model pwr400dgta?

How do I remove spool housing attached to the motor, to enable access to motor bearings. Performance Power To... [Read more]

echo srm 360 sl ?

My employer has an Echo SRM 360 SL grass trimmer. How do I advance the line and, when I want to remove head,... [Read more]

Is the retaining nut on a Black & Decer GW250 a "left-handed"thread?

I am going to fit a new impeller to my Black & Decker Leaf Sucker/Blower (GW250), and need to know which way t... [Read more]

how do i get rid of the horrible loud noise on my russell hobbs 18noisey ?

my 1800w russell hobbs makes such a row when switched on how do i get rid of it.....embarrassing to switch on

how can I fix my ryobi rlt 30 cesa weed wacker (strimmer)?

Had it 2 years. Not used a lot. Drips fuel from where one of fuel lines enters tank. Changes to a stream whe... [Read more]

my JCB trimmers run for a few minutes then pack's in help?

When you try to start it runs even less time then won't start because it's floodin

how to fix my brush cutter?

my brush cutter bought from Aldi few years back keeps running when it is on idle mode but start to die out whe... [Read more]

ignition coil for JCB -PLT25?

Replacement ignition coil for JCB-PLT25 line strimmer

how can I fix my ryobi RLT30 CESA grass trimmer?

fuel tank cap tightly closed but petrol keeps dripping quite quickly from somewhere.