Mend GBC Ultima 65 Document Laminators

Mend Office Appliances, Document Laminators

Find out how to mend it for free.

Click here to mend GBC Ultima 65 document laminators

Mend Document Laminators

Mend Document Laminators

Mend > Document Laminators

GBC Ultima 65 problem?

GBC Ultima 65 I repair these, but I don't see too many I only know of 3 in Dublin, however I have one that's stopping cooling and starting I took off the covers and ran without the chain, the motor seems fine but was still stopping its about 7-9 yrs old any ideas ???.

Paul
September 2014

GBC GBC Ultima 65 Office Appliances, Document Laminators Gbc Ultima 65 Problem

Paul I service all brands of roll laminators around the pittsburg pennsylvania area. Feel free to give me a call.

The bearings on the red rollers, sometimes the grease turns to rock hard. this causes the rollers to stall and can stall he entire machine. In addition the motors can go bad, and stall.

the interlock switches may fail, the control panels membrame swithch can cause stopping too

bob haller service and sales 412 848 0101
September 2014

It's a heavy duty laminator about £1600

It runs - stops - cools down - and starts again.

I would guess that an overheat sensor causes the machine to stop - when it cools to an acceptable temperature the sensor resets itself and the laminator starts up again.

If this is what's happening then either the sensor is working as it should and things are too hot - or the sensor is too sensitive and the temperature is within limits.

But I know nothing - my idea is just a guess.

Good luck...

Éamon de Valera
September 2014