Miele G692 SC Plus JRBOTHERMIC dishwasher won't fill?

Thanks Bernii. I tracked the problem down to a few burnt components on the circuit board. Certainly a micro switch that powered the inlet valve, and a capacitor next to it. The board itself was very expensive to replace (over $600). I tried replacing the components (had to borrow a switch from the end of the board that used to control the salt thing) and repair a few tracks. I now have it sending about 28 volts to the inlet solenoids, but no action. Question is, do the solenoids require 240 volts, and I hav'nt succeeded in repairing the board, or is the voltage right, and the problem likely to be faulty solenoids?

Richard Bush
July 2011

Check the connections to the solenoids for burn marks caused by a leak.
The solenoids won't get power if the overflow pressure switch is switched as they are wired in series.
Also the flow meter board may be faulty.
Does the drain pump continuously run ?

Bernii
March 2011