WDM120 washer dryer, Hoover doesn't empty?

What way do the connections go back on? I'm a fool and didn't take note

James
February 2015

Look at the controller board next to the motor in the bottom of the machine; if you take this out (three terminals connected) you will see two relays, turn the circuit board over and inspect for dry joints (use a circuit tester from the the edge of the board to each of the relay solder points.. Mine had a dry joint, I resoldered and the machine sprang into live..Cost £0!! :).. Oh make sure you cable tie the wires back otherwise they might get taggled in the motor.

Tony
September 2007

I changed the controller board and the machine worked correctly again.

Ed Long
October 2006