I have reset this system after being dormant. When I enter user code now it comes up MAINS FAIL however the mains lamp is glowing to indicate mains power in use.
guess you not want to know,:-) all is well in the world,
gts
February 2011
if you wish to know how this is done,come back here,
its very easy,once you know how :-)
gts
February 2011
your panel has been left on engineer reset,witch means that you will have to through that routine each time it triggers,you should reprogramme it to user reset,
that means you can reset it by just keying in yyour number,
gts
February 2011
your welcome,
gts
February 2011
That did the trick. Thank you V much.
Nicky B
February 2011
i will be here for a while
gts
February 2011
it could be,try 07890,see what happens it may show installer mode on keypad,if it does,key in 99 then press the tick,it will ask leave engineering,press the tick,it will then say checking system,then it will show date and time,
you are now reset,try this and get back,
gts
February 2011
Hi,
As soon as I enter my user number it wont accept any other entries.
Does it need an engineer reset or setting back to factory default?
Thanks
Nicky B
February 2011
are you looking at the log by any chance?if not,rekey your pin num ,then press the tick
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix home alarm systems.