Mend Scantronic 9800 Home Alarm Systems

Mend Security Systems, Home Alarm Systems

Find out how to mend it for free.

Ask Question

Mend repair fix Scantronic 9800 home alarm systems

Mend home alarm systems ...

Mend Home Alarm Systems

Mend > Home Alarm Systems

scantronic 9800?

hi i moved into my house 3 years ago and installed from 93 was a scantronic alarm no one knew the code and after a few failed atemps i removed the red wire from the rear of the key pad i recently powered it up again and it flashes "sr" system reset can any one tell me the procedure to reset the alarm with a new code thanks

rob j
February 2010

Scantronic 9800 Security Systems, Home Alarm Systems Moved House Ago

If the user &/or engineer codes are lost,

1. First remove mains power before opening the case & then disconnecting the battery.
2. Identify & remove the NVM chip (IC4) on the main pcb
3. Reconnect the battery, then re-apply mains power.
4. Refit the NVM chip (note the locator marker position)
The end station loads the factory default access codes (User 1: 1234, engineer: 7890).
5. THEN carry on to RE-PROGRAM the WHOLE SYSTEM.

Without the Installation manual, you're st***ed.

Suggest you find an engineer who knows this panel

acorn
February 2010