I am after the user manual/ instructions for the Scantronic 9448, the lights and sensors are working but I cannot set the alarm. I guess I need to reset. Had the manual at 1 point and tried by following reset instructions in it, but no luck. Will I need the technical manual rather?
Where can I get reasonalble new battery for it?
Looking forward to your reply!!
remove mains power,open panel remove red lead from battery,on the pc board there are two pins,put a wire between these,put lead back on the battery,then put remove the link,close the panel,put mais back on,you have now restore the panel back to factory settings,i.e.if you want to put your code in,key in 0 .enter 7890.
then your code,then press 99 enter,
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix home alarm systems.