pyronix deltabell plus wiring ?

Here is the correct answewr and not a straight lift from the instruction booklet.

Acc4 Panel+++++++++++++++++deltabellplus

St+ (not used)
St- ====================== Stb
T ====================== second down T
A ====================== top T
D ====================== 12v+
B ====================== Bell
Then place a wire link between topT and 12v- in the deltabellplus.

Doopherdaffer
August 2011

Hi Matt, the connections on the pyronix deltabell are as follows:
-12v = Hold off negative supply
+12v = Hold off Positive supply
BELL = To bell terminal on Panel
STB = To strobe terminal on Panel
ENG HOLD = Terminal to allow maintenace in Engineer mode (Would't worry too much about this)
T = Tamper Return to Panel
T = Tamper Feed (Link this terminal to the -12v terminal in bellbox)
Hope that helps (:-)
AJP

regards

ap
February 2011