I HAVE A JOHN DEERE 2001 6810 TRACTOR, I WENT TO START IT AND IT TURNED OVER AND LIGHTS WENT OUT IN DASH. I FOUND OUT FUSE WENT PUT NEW FUSE IN TURNED ON IGNITION LIGHTS UP DASH WENT TO START AND BLOWS FUSES. I THEN REPLACED FUSE TURNED TO LIGHT UP DASH RUN FLY LEAD TO STARTER AND STARTED TRACTOR. WHILE TRYING TO START TRACTOR I NOW CANT SEEM TO GET GEARS WHEN TRACTOR IS STARTED HOPE U CAN HELP ME WITH THIS THANKS
RAFF.
Hi, have a john Deere 6510 , power quad gearbox, struggling to change gear, is this a clutch pack problem or worn linkages or both
Nick
May 2016
hello, did yoy find the problem i have the same problem when turning key in start position fuse 1 blow out.
richard
September 2014
That'll be the top fuse in load center 1 ?? should be 30A as I recall, I've seen the engine stop solenoid wire short to ground near the pump, also check the wires to the tank pump on top of the fuel tank accessed via the hole under the carpet. Does the fuse blow at the ignition stage of the key or when turned to start position??
W
W
December 2009
Hi w,
The forward and reverse switch up beside the steering wheel wont work.
The first fuse closest to steering is the one that blows the ignition switch fuse
Hope this helps thanks!!!
RAFF
November 2009
Which fuse blows? You say you can't get gears??? now do you mean you can't get the ranges A, B, C, D, E, or you can't get the speeds of the powrquad to work & I presume it's powrquad plus (electrically shifted)?
W
November 2009
Automatic Answer
While you wait for answers, we may have found some information which could help you.
howtomendit.com for free repair help, information and advice.
