miele g645sc inlet/drain light comes on after fills about 5 mins in?

You may have some water in the drip tray in the bottom of the machine. ISOLATE THE ELECTRICS....
1 / Take the plastic fairing off below the door with the two phillips either side of the the machine.
2 / Take the access panel off by undoing the two phillips screws along the top of the panel.
3 / Mop up any residual water, especially around the sump float switch that may have been activated.
4 / You may have to reset the machine........now I did this anyway after reading a thread somewhere - hold the on/off sw and start sw at the same time for a minute.
........anyway, it worked after having done the above and I ran it with the front panel off and no signs of any leaks.......all good so far.

Dobulas
July 2010