Recent: Fix food processor motor?

Mend Fisher & Paykel Dishwashers

Mend Kitchen Appliances, Dishwashers
Find out how to mend it for free.

Ask Question
Mend Kitchen Appliances, Dishwashers
Click here to mend Fisher & Paykel dishwashers

Mend > Dishwashers

Mend Fisher & Paykel Nautilus Dishwasher

Fisher and Paykel nautilus 920 dishwasher displays a F1 AFTER fix?

Fisher and Paykel nautilus 920 dishwasher displays a F1 fault. The control consol circuit board has just been replaced after appearing to arc at the heater element terminals. Disconnected the two wires to flood sensor switch (F1 fault) but fault code remains.

Peter H
March 2009
Disconnecting the wires to the flood switch will actually cause the fault. Connect the two wires back on to the flood switch using the two outside pins of the 3 in the connector. Make sure float is sitting right down & not operating flood switch. You can raise & lower float manually & should hear switch click on & off. Also check for any corrosion on switch or terminals that would cause a bad connection.

Lincoln Appliance NZ
April 2009

Automatic Answer

We may have found other answers which could help you.

Click here for Fisher Paykel Nautilus Dishwasher

Mend Kitchen Appliances, Dishwashers
Click here to mend Fisher & Paykel dishwashers

Other models...

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Kitchen Appliances, Dishwashers
Click here to mend Fisher & Paykel dishwashers