How to mend ... Will Feed Way

strimmer?

how do i make the auto feed work on my flymo strimmer

How to fix my Navman F20 because I voided warranty when I took it apart?

I have a problem with my Navman F20. The place where I plug the unit into my 12volt charger has broken. Now I ... [Read more]

Bosch Classix dishwasher - no more hot water?

The dishwasher runs through the cycle but the plates come out wet at the end and grease doesn't come off. I've... [Read more]

Vectra C rear wiper not working?

Vectra C rear wiper not working. Told not the fuse not the stalk no feed to the motor could be the R.E.C. Tol... [Read more]

JCB 3C111 Heads or Sumps?

Thank you for your advice again. Following your suggestions I calculated that the coolant level was about 2 li... [Read more]

epson stylus photo rx420?

paper will not feed, have tried epson suggested fixing suggestionsstill not working , can l fix it myself.

worcester 24i combi , overflow leaking , pressure to 3 bar , ?

just replaced water feed and another part which started to leak after i had blown the system of water, i thin... [Read more]

McCulloch MT161 Strimmer?

I have the above older!!! model of strimmer, which still works excellently, but I am unable to locate the line... [Read more]

relay engine?

t reg dispatch van i bought had wrong engine fitted managed to track down an engine 1.9 diesil from a citrion ... [Read more]

Dyson D01 - power arriving at switch but no further even though switch OK?

I have a DC01 with no power past the switch. I have removed the switch and tested it in isolation - it is OK. ... [Read more]

How can I fix my Amstrad A2S0609 Sky + box?

The box now seems to have only one feed into it. It is not the LNB (Tested That) As a result I am paying for... [Read more]

escort van 55 diesel,1998 wont turn over?

started bein tempremental,turn the key with no response,swapped the starter n still no joy,bypassed the igniti... [Read more]

Damaged electrics in Ikea light fitting- how to fix?

I purchased a light fitting from Ikea and attempted to fit it earlier today. However, I have made a mess of it... [Read more]

Bump line feed for grass trimmer?

Challenge Xtreme M1g-ZP-250

Motivator stairlift stopped working?

Hi.My dad has the motivator 1000 series stairlift which hasn't been used since mum passed away 9 months ago.He... [Read more]

near side back light is not working?

Sprinter 311... My nearside rear back light is not working, Its as new bulb, I have looked for an appropriate ... [Read more]

canon 6030 error message?

this copy can't be used in this mode appears when using bypass tray( manual feed)

Wiring twoway two gang switches?

I am fitting two wall lights on one circuit and a ceiling florecent on a two gang two way switch. I am gettin... [Read more]

Earthing a Metal Wall Light?

I have an existing metal wall light which contains an earth connector but no wire. The original installati... [Read more]

projector ?

Where would I get the rubber feed gromet for the Bell and Howell model 456. Mine melted from the heat ... [Read more]