How to mend ... Went Back Since

Wiring diagram for the power switch?

Hi Checked mine and as per Robbie dry solder joint was found but when putting panel back together the wires c... [Read more]

How do I repressurise my cb28?

I have just changed lthe heat exchange and switch and put new diverta valve diaphragm in with new washers but ... [Read more]

Ignition timing adjust?

My Ryobi RCT2800b fires too early so the piston will not go over TDC but kicks back. How do I adjust the timin... [Read more]

Hotpoint ultima dwf60 display indicator panel?

How do I remove the fascia panel by the on off button to enable the display indicator cover to be pressed back... [Read more]

Leaking f and p washer?

Seemingly common question. Fisher and Paykel ELBA started leaking near the recirc tube during the rinse cycle.... [Read more]

Replacement pause/start plastic back plate?

I have a SMEG DF612SDX dishwasher. The program and start/pause buttons push 2 very fragile plastic flanges th... [Read more]

Why no wash on Hotpoint Wf541 after putting new door seal in?

I've just replaced the plastic door seal on a Hotpoint WF 541. Everything went great, then closed door started... [Read more]

hinges/back plates?

I removed my oven door to clean it, as I unscrewed it I didn't realise the back plates would fall off. How do ... [Read more]

206cc roof wont open?

206cc 2006 roof won't open windows come down about an inch than that's it . If you put the windows down then t... [Read more]

warning light come on and cut of my corsa?

Hi i have a corsa classic 1.6i 2001 model , my engine warning come on at first the garage changed the crank ce... [Read more]

technika lcd37-907?

 "Hello mate iv got a technika lcd37-907 and its not turning on the blue light comes on so its got power ther... [Read more]

can I fix my bose by myself?

My bose does not pull the cd in all the way, I can push it in manually, it then says "reading" then it says "n... [Read more]

Can it just be lose wiring?

when i got my 2013 tao tao i caught an a!$#hole rolling out my drive with it. I did catch him but he effed up ... [Read more]

how can i change my shifter on my snapper rear engine mower?

the shifter keeps bending and I have one off an older mower that seems to be heavier. If I just clip the cot... [Read more]

veritas ?

home alarm is in temper mode how can it be reset back to normal?

sebo auto x4 vacuum cable replacement?

Same as Rik, The handle fixing nut, or whatever it is, is now rattling about inside the handle. And more annoy... [Read more]

stannah 260 stair lift will not go back up after stopping at the bottom?

hi when the chair lift reaches the bottom and stops it will not go back up unless i wind it back up a few inch... [Read more]

How can I fix my CL on a Vaux Zafira 00?

Locked the car yest it made a couple of noises but locked. Went to use in the aft and had to use key to open a... [Read more]

How can I fix my fridge/freezer candy cic324ak ?

Switched off fridge/freezer to defrost, when switched back on compressor will not run

Rnault master horseboxes?

I hit the side of a wall and took the paint work off the side of the van but then the wall as hit the wheel an... [Read more]