How to mend ... Reset Set Setting

Scantronic 9651 aux dc fail?

I have just amended the programmed zones so that the kitchen sensor is not set when setting the system using B... [Read more]

red flashing button siemens RCRIO/433?

red button keeps going from green to red on RCRIO/433 Receiver, the boilers temperature often goes a degree a... [Read more]

combi oil Worcester greenstar heatslave 12/18 switches off?

I have a internal combi oil Worcester greenstar heatslave 12/18 Its has a built programmer and Hot water t... [Read more]

Can anyone tell me how to set up a carb on a hulk evolution wacker ?

I have the problem of fuel not getting through to the carb I have cleaned everything and I have had it running... [Read more]

SL Compact BUtton Beep Volume Too High ?

Hi, I have an SL Compact alarm system installed. We set it every night going to bed. My wife set it the al... [Read more]

Alarm not setting?

I have a Veritas R8 alarm (one pad at front door and one at the back.) the issue -as and from last night when ... [Read more]

No power light showing on ?

Hi Have a intellisense 800 l+ Electricty went off setting alarm off when power returned on we have power to co... [Read more]

intermittant Siemens RDJ10RF/SET fault?

RDJ10RF - tried the reset procedure. Have a solid green light. Works in a morning to turn heating on 'preset 1... [Read more]

glo worm ultracom cxi CH works but water only warm?

glo worm ultracom cxi CH works but water only warm even set on highest setting. Will pressing reset button hel... [Read more]

Siemens remote thermostat RDJ10RF doing opposite to setting?

My Siemens remote thermostat does the opposite to what i set it to. The time i set it to turn the heating on,... [Read more]

How can I fix a heating problem with our YKEMC307KS0 oven?

We have a temperature control problem with our Kitchen Aid YKEMC307KS0 oven/microwave combo unit. When you se... [Read more]

tamper light will not go out after reset try set alarm it show on and will ?

the tamper light stays on when setting alarm. tried to reset light gose out but one of the light comes on and... [Read more]

Scantronic 9800 programmable outputs not responding?

I can't get either programmable output 1 or 2 to work. I have the manual, and have reprogrammed the whole sys... [Read more]

Glowworm 330+ boiler starts up at night?

The boiler starts up at night despite both system controls being set to off and it not being cold enough for t... [Read more]

Vaillant Ecotec plus 824 with no central heating?

Please help!! We've been in this house for almost a year - so I'm not sure when the boiler was installed bu... [Read more]

Scantronic 9800 problem - how can I get it to work?

A Scantronic 9800 was fitted to my house many years ago and the very elderly previous owner lost the codes and... [Read more]

Beko DRCS68W not entering reset mode?

Hello everyone, I am having issues with my Beko DRCS68W condenser tumble dryer. It started when the drum got s... [Read more]

varitas alarm not setting?

hi i cannot seem to set my varitas alarm, the reset yellow led light keeps flashing continuesly.this never hap... [Read more]

Keypad dislodged from the housing setting off the tamper alarm?

Hi my keypad became dislodged from the housing, on carefully fitting it back on the tamper sensor was set off.... [Read more]

Re setting Engine?

How can I reset a Renault Laguna engine when it cannot start (immobiliser has set in)?