How to mend ... Reset Default Help

Scantronic 9600 problem?

Hi All, Just been given a job to get the above alarm working again but I have no access codes to the system a... [Read more]

Could the NVM chip be dead after 13 years?

I put my system into engineers mode (0xxxx then opened panel, E displayed). This was to allow me to disconnect... [Read more]

Why can I not set my alarm system?

Optimax XM6 system. Basically, when decorating a room I accidently cut through one of the sensors alarm wir... [Read more]

how can i restore the caller display on my bench kh5001 comfort telephone?

For no apparent reason I have lost the "caller number display" facility on my BENCH KH5001 analogue comfort te... [Read more]

Optima accenta g3 system locked, panel shut down?

I was removing a PIR sensor from the wall when decorating and set the tamper off a few times whilst removing/r... [Read more]

veritas 8c?

iv finaly got my alarm working after powering it down but the problem now is i cant reset my entry time so it ... [Read more]

message about the optima 2 plus for paul flower from death ?

hi paul yes your alarm can be switched off and i will help you as much as i can . to do this i will step to ... [Read more]

9452- Forgotten Alarm Code- How can i reset?

I have been renting my house out for the past 3 years. Went in the other day and the alarm keeps going off. I ... [Read more]

Old Wickes hard wire 5 zone alarm ? reset PIN?

Tenants have changed the PIN on an old (10yrs)Wickes hard wired alarm and left without leaving new PIN. I have... [Read more]

IE not functioning?

wots going on? internet explorer is not working. cant seem to type in addresses without Bing interfering. so s... [Read more]

fta101 has totally froze?

my fta101 box has froze, tryed doing factory reset, scanned all channels back on, switched emu on but the chan... [Read more]

Reset the system?

How can I reset the system to default?

accenta mini G4 alarm is always ringing?

My accenta mini g4 alarm is always ringing so I have had to switch it off. Is there a default code I can punch... [Read more]

How can I fix the E32 problem with Sharp ER-A440?

I have done a master reset - so the memory is cleared and keyboard is back to default layout (I believe).

ACCENTA + G3 - PROBLEM AFTER POWER FAILURE with setting zones?

After a recent power failure my alarm seemed to restore itself to its factory settings. My code would not work... [Read more]

how can i fix my sl concept code?

how do i reset a sl concept alarm to a default engineering no as i have no install instructions but i do hav... [Read more]

How to play recordings when Recorded Program list lost?

Following advice from another thread (which was received enthusiastically by dozens of other people with the s... [Read more]

bt synergy 3105 pin number?

I have a ebay purchase bt synergy phone 3105 which will not respond to "0000" pin number. How do I reset the l... [Read more]

how can i reset conia stbCSTB300?

hi my settop box is in VGA mode, so i have not got a picture ,so cannot access the menu to change it , does an... [Read more]

Veritas 8c?

Hi, My friends recently bought a house which was a repossesion and there is a Veritas 8c alarm fitted which t... [Read more]