How to mend ... Replaced Thermal Cut

Water not heating up on redring expressions 500 8.5 kw? ?

The overheat light comes on. I have replaced the thermal cut out with a new one but the problem is still the s... [Read more]

How can I replace the thermal cut out in a Baumatic B600 single oven?

I recently replaced the element in my oven, but now the oven keeps heating and doesn't cut out when it gets to... [Read more]

Tritin Jade running hot and cold?

Recently replaced the solenoid on my "Jade" to cure a water flow problem. Everything has worked fine until las... [Read more]

Main oven getting too hot on Electrolux EKC5544W?

This is a follow on from a previous problem (http://www.howtomendit.com/answers.php?id=327752). So I had the ... [Read more]

Worcester 19/24CBI Problems (Over Heating, Fail to ingite)?

Hoping that someone can shed a little light on my problem or that this may help someone in a similar position.... [Read more]

How can I get my dyson vacuum cleaner working?

I have a dyson DC07 vacuum cleaner which has stopped working. There was a strong electrical smell just prior t... [Read more]

eob 5630x under counter oven?

replaced fault thermal cut out oven still not operating no diagram to follow the two blue wires of new switch... [Read more]

Looking for a thermal cut out for DC07?

does anyone know where to purchase this part as i have cleaned and replaced all filters but it still winn not ... [Read more]

AEG Main Oven Cutting out?

I have an AEG double built in oven ref CD 81001A Alutec purchased in 2003. It was under guarantee until 2008 b... [Read more]

Thermal cut out tripping on glowworm ultimate 120FF ?

The over-heat cut out keeps tripping after a couple of minutes..fan working ok, pcb fine and thermostat and cu... [Read more]

Hotpoint WD61 motor fails to run?

Problem with Hotpoint WD61 washer dryer: this may be a bit old now but it’s quite “low mileage” and does... [Read more]

Triton shower intermittently heats & cools?

Hi my Triton Biarritz has been intermittently going from hot to cold, had a look, found cable from 1st thermal... [Read more]

my creda tcr13 tumble dryer is not heating?

I replaced the thermal cut outs but still not heating.

How can I reset my electric shower Gainsborough 10.5 SCL?

How can I reset or replace the thermal cutout switch on my electric shower a Gainsborough 10.5 SCL. This i... [Read more]

TDC30P Will Not Heat?

I have inherited a Hotpoint Aquarius TDC30P that will not heat, the previous owner replaced one of the two the... [Read more]

Zanussi TD520 Tumble Dryer is cutting out before end of cycle?

The machine cuts out towards the end of the cycle, almost as if it is over heating. Is there a thermal cut ou... [Read more]

Bosch WTA 2000/01 tumble dryer not heating up?

Replaced element in Bosch WTA200/01 tumble dryer but still not heating up - is this a faulty thermal cut out p... [Read more]

Low Water Flow?

I recently replaced the Hot Water Recirc Pump (used to give Instant Hot Water to all sink faucets). Purchased... [Read more]

Dyson DC 07 Stops every 5-10 mins?

Can anybody help, my husband has taken it apart twice, cleaned all the filters and replaced the motor one - bu... [Read more]

creda 37747 tumble dryer thermal cut out switches help?

There are 4 wires of different colours and there are 2 cut out switches one is marked with a red dot and has t... [Read more]