Recent: Gardenline GLS 36K scarifier?

Free repair help and information

howtomendit.com find out how to mend just about anything.
Categories

Mend New Went Round

Free repair help

We have 3029 questions about mending 'new went round'

How to mend ... New Went Round

Mend Household Appliances, Vacuum Cleaners

thread wrapped round motor in dyson?

Nylon thread from carpet wrapped round motor of dyson - can't get into it to unravel - any suggestions
Mend help light dash

rab mcityre re fiat bravo help?

the light that has come on the dash board is a red light with broken lines round it the shaking in the wheel o... [Read more]
Mend dryer checked turn

hotpoint dryer?

hi have a hotpoint dryer and it smells of burning i have checked the belt and thats ok then i put my hand insi... [Read more]
Mend zanussi 1000 machine

the rubber seal has come off from my Zanussi turbodry 1000 washing machine?

How can i fix it there is also two other parts that have come off a big round spring and a round plastic holde... [Read more]
Mend lighting going replace

Lighting & Sockets?

Not going to put in two catagories so here goes. Although not an electrician but a competent DIYer I want t... [Read more]
Mend round corner car

vetcra banging?

when i go round a corner there is a huge bang from under the car all bushes are ok and springs fine and i dont... [Read more]
Mend condensor tumble dryer

proline condensor tumble dryer tdc7a?

when the drum turns round it makes a clunk noise, what could be the cause of this
Mend dryer button time

hotpoint ctd40p ?

tumble dryer going round no heat at all on off button flashing and time delay button flashing, appliance 18 mo... [Read more]
Mend Video, Film Projectors

I need a lamp for my Pathe Son 9.5mm projector?

Details of old lamp is, OSRAM, GEC.12V 100W. It has a letter T on the side of the base which acts as a guide... [Read more]
Mend oven fan hand

electrolux oven?

my fan on an eob976 will no turn round but will with my hand when turned off
Mend hot point water

hot point washing machine 9540?

the timer switch does not move round any more and after a while the water in the drum got very hot is it timer... [Read more]
Mend signal very low

Input Signal Very Low Sky+?

The Input Strength Signal on my Amstrad A1 P0610 Sky+ box is barely registering tho the Quality is High, only ... [Read more]
Mend purchase model number

purchase needles?

Where can I purchase needles for a sewing machine model number 915826? Must be round machine needles.
Mend leaking onto floor

My toilet is leaking from the base onto the floor?

My toilet is leaking water from the base under the bowl onto the bathroom floor, this started happening after ... [Read more]
Mend ariston 2000 machine

What would it cost to fix?

My Ariston 2000 w/dryer Started Wash load (no4) The Machine Drew in some water then stopped. We tried moving t... [Read more]
Mend bread maker drive belt

Princess Bread Maker drive belt?

Please advise whether you can supply me the above which is 8mm wide and 52cm circumference (round) and what is... [Read more]
Mend glow work boiler

Glow worm 100e - how warm should the control panel get?

Hi. We've had some work done on this boiler. Domestic hot water was fine - central heating was triping. I... [Read more]
Mend wiring ceiling rose

Wiring a ceiling rose?

The are some missing light fittings in my new house and I want to install simple pendants for the time being. ... [Read more]
Mend panasonic going remove

panasonic pt-ax100e?

keeps going to standby. stays on if you remove the top and mess round with a brown block with a piece of coppe... [Read more]
Mend leaking flush pipe

how do I remeve the cistern off my villers & Boch toilet ?

I have a Villers and Boch toilet which is leaking when i flush it. I have identifired that it is the flusher p... [Read more]

Ask Question

Ask your question Do you need free help? Ask your question.

howtomendit.com for free repair help, information and advice.
Ask Question