Recent: Fix food processor motor?

Mend Panasonic Video Projectors

Mend Video, Video Projectors
Find out how to mend it for free.

Ask Question
Mend Video, Video Projectors
Click here to mend Panasonic video projectors

Mend > Video Projectors

Mend Panasonic Going Remove

panasonic pt-ax100e?

keeps going to standby. stays on if you remove the top and mess round with a brown block with a piece of copper wire

peter
July 2009
I had the same problem and someone told me the solution. Take the lamp cover off and inside you will see a brown block that pivots right in the corner of the lamp holder, try moving it forward with a screwdriver and if it comes back very very slowly then use a cotton bud/tip spray some silicon spray or WD40 on the bud and dab the grease on the left and right side of the pivot (one end has a finishing cap on and the other side is covered with a small spring. It's easier to remove the bulb.

This block is something to do with the lower iris as I was told, seems to be a very common problem with them!

Once the grease has been applied, use a small screwdriver to move the block in it's full range and eventually it will spring back in under a second.

www.youtube.com/watch?v=6jGwB05_gdk

Iain
December 2009

Automatic Answer

While you wait for answers, we may have found some information which could help you.

Click here for Panasonic Going Remove

Mend Video, Video Projectors
Click here to mend Panasonic video projectors

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Video, Video Projectors
Click here to mend Panasonic video projectors