How to mend Heater Element Ohms

1

Hotpoint BF168 Dishwasher not drying?

I suspected this would be the heater tube element but on testing its resistance I'm getting 26 ohms which seem... [Read more]

5

Hotpoint aquarius 1100 (WM63) trips main power?

Washing machine trips the main power when switched on but after the water has filled up. I have read some art... [Read more]

1

Flashing main wash light Miele W838 washing machine?

From perusing many forums, I learnt that when the main wash light keeps on flashing this means there is a faul... [Read more]

3

Hotpoint WD440?

Hi, i have a hotpoint wd440 washer dryer, a few weeks ago when using the tumble dryer it was tripping an rcd, ... [Read more]

2

Is there a stat on a Beko DRCS76W dryer heater unit?

I have a Beko DRCS76W dryer which is only just blowing warm. Checking the resistance across each element shows... [Read more]

water not getting hot whirlpool adg7540 dishwasher?

i have taken the heater element out and connected it to a seperate 240 volt supply and it gets hot.I have also... [Read more]

2

Creda cooker oven fault?

The main oven heater element has once again blown on my Creda Reflection 48196 cooker..I have fitted a new ele... [Read more]

5

Hotpoint FDW60 - Flashing Fast + Delicate lights. Heater element = 260 ohms?

Hi. After reading lots of Forum posts about this being the heater element I took my Dishwasher apart and me... [Read more]

Triton Opal 2 Trips out RCD?

My Opal 2 shower trips the RCD in my consumer unit just as the heater element would start to heat the water, I... [Read more]

3

Bosch Frost free freezer has frozen up - why?

My mother in law has a Bosch KDN30X00GB/01 Upright fridge freezer (freezer at top). The evaporator had frozen ... [Read more]

3

AEG 18630 Washer/Dryer won't dry properly?

The drying cycle had been exhibiting "Zanussi Time", counting down too fast and leaving the clothes cool and w... [Read more]

1

How can I fix my Bosch washing machine?

How can I fix my Bosch WFF 2000 washing machine which is not heating the water. The heater element seems OK. ... [Read more]

2

Simpson Maxidry 452 shorting mains saftey switch?

Hi there i have a simpson maxidry 452, when running it wthout turning the heating switch on it seems to run fi... [Read more]

2

no heat from Whirlpool AWZ 7813 Tumble Dryer?

Whirlpool dryer model AWZ 7813 no heat, even though thermostat set has been replaced,( no continuity on the up... [Read more]

1

Smoke from Bosch Exxcel 1400?

Problem with a Bosch Exxcel 1400 (WVT2850GB/02). During a wash, my machine started smoking from the back an... [Read more]

4

Rover 25 diesel electical help required?

I have a number of small problems on the car, a 2001 model. 1. Heater fan does't work on position 1; I can fi... [Read more]

1

Removing backplate screws to replace a heater element?

I need to check and possibly replace the heater element in my fan assisted Bosch oven. The oven is 6 years onl... [Read more]

2

Dometic Refrigerator Controller board 5 amp fuse blows at power on?

When I power on the refrigerator the controller board 5 amp fuse blows immediately. I assume that I have a sho... [Read more]

1

mira 10.8kw tripped rcd and then would have o hotwate when switched back on?

re: switch off all power to the shower and locate and disconnect the terminals to the heater element. Use a mu... [Read more]

5

zanussi de6744?

water dose not heat up and program will not finish, i have tested the heater element which is okay it has an ... [Read more]