Mend > Motorcycles

we only got 25 psi ?

only gettin 25 psi so does that mean interior engine fault ?and wot do i av to do now?

peugeot bolt?

i have a peugeout speedfight 2 57 plate i tuke the carb off and wanted to change the reads but the inlet on to... [Read more]

peugeot restrictors ?

does any one no were all the restrictors are in a 50cc peugeot speedfight 2 57 plate need help plz

got a spark and petrol gettin through but still wont start ?

speed fighter 2 100 cc had a new choke put on gave the bike a gd run out got so far n then cut out on me wen d... [Read more]

speedfight 2 50cc?

hi adam bike doctor its dy2 just a quick question my bike starts and ticks over for about 30 seconds then cuts... [Read more]

dna 125 Gilera?

Hi, I have a Gilera DNA 125. It is completly standard except pipe. The pipe is a Scorpion. It is a 53 plate 9... [Read more]

how do i make my mini dirt bike go?

it will start up fine with no choke, it will rev but then i put the choke down and give it revs and it cuts ou... [Read more]

speedfight 2 50cc?

hi i have a speedfight 2 50cc 2006 plate i need a oil pump for my bike as any body on here got one for sale if... [Read more]

Where to I start?

The lights, indicators,horn have stopped working ON MY granddaughters YAMAHA NEOS SCOOTER 50CC

starter pinion for speedfight 2 100cc?

ive just drowned my starter pinion in wd40 as it was seazed. it all loose and fine now. my question is: do ... [Read more]

maruader 125 choke?

Ok, our 125 Maruader has the cv carb with cable that goes into the carb on the top left hand side. The carb ha... [Read more]

carbs?

how do you clean out the carbs on a gilera dna 50cc moped?

are my lights working properly on my moped?

i have a sukida 50 cc roma when i put my lights to dip only a red light comes on is this correct

spark problam with speedy?

hi can eney one tell me wy im getting no spark on my peugeot speedfight 100cc. i was riding it the over n ight... [Read more]

1988 kawasaki zx10 wont start when hot?

1988 kawasaki zx10 wont start when hot but starts from cold and runs with no problem

How do I keep the plastic gear link rod from falling off on PUG 206? ?

I have two plastic gear link rods about 6" in length and the bottom lever/rod keeps loosening from the metal d... [Read more]

how do i fix the noise on my motorbike?

i have a kawasaki zzr600 1990. i have just got the timing chain and ajuster replaced. but i have a tapping noi... [Read more]

how to fix my mini moto?

my mini moto will start with full throttle and choke on but as soon as the choke is off it cuts off.the engine... [Read more]

Speedfight 2 fix needed Leeds Area?

Alright everyone.I have tried what my knowledge and know-how will allow to try and fix my speedfight,but unfor... [Read more]

need help wit my blinkers?

my dad bot me a moped wiv bad electrix. its a streetfitter 2 n wen i go to turn left r rite at a turn n switch... [Read more]