Mend > Washing Machines

4

how can I fix my hotpoint ca230?

the washing gets to the last cycle it is supposed to fast spin but all it does is pump out, leaving the clothe... [Read more]

1

Indesit WD12s UK ...how to change drum bearing???

i have bought a spare drum bearing for my washing machine. But i found it had to change the part. First of all... [Read more]

3

Kenmore Model 110.29842991 doesn't spin?

My Kenmore Model 110.29842991 won't start the spin cycle. It agitates, clicks as if it's going to the spin cy... [Read more]

1

Indesit WE16 Error F-03?

Machine constantly flashing up F-03, if switch off and leave off for a while machine comes back on ok, can sel... [Read more]

1

How do I change the knob for the timer?

The knob on the washer to turn the timer broke.Timer still works,but don't know how to remove the knob. Is the... [Read more]

1

diagram of a hotpoint washing machine motor?

hot point first edition 1000 washing machine

1

My washer will not go into wash cycle help?

The water will fill, but the cycle will not start. After looking inside I noticed the first belt from the bott... [Read more]

3

Kenmore Model 80, how can I confirm if I have a washer timer problem?

I have a Kenmore series 80, Model 110.20882990 clothes washer and I think I have a Timer problem. The washer ... [Read more]

1

How to fix a hotpoint washer dryer?

My hotpoint washer dryer wd 71 displayed an error 'e 30' and since I replaced the motor it does not display'se... [Read more]

1

whirlpool washing machine awm1403 circuit diagram or service manual?

Does anyone know where to find this data? Rgds Peter peter@tvtechy.fsnet.co.uk

2

zanussi fjs 1397w jet stream?

just fitted new drum bearings. now it fills with water turns a couple of times and then blows my main fuse box... [Read more]

4

Maytag washer will not agitate?

Maytag washer model number PAV1000AWW. The washer fills with water then starts humming loud, then smells like... [Read more]

1

Broken Coupler?

I found the coupler in my Serise 90 Kenmore washer broke. How do I replace it?

1

The sanussi fl828 is over filling with water and some times overflows?

The sanussi fl828 is over filling with water and some times overflows. what controls the water level in the ma... [Read more]

1

MY ZANUSSI FL 1282 DOES NOT USE THE HOT WATER?

MY ZANUSSI FL 1282,ALTHOUGH FITTED WITH BOTH HOT AND COLD WATER INLETS,IS NOT USING THE HOT WATER.MY PREVIOUS ... [Read more]

1

Amana washing machine model #DLW330RAW?

I need to replace the boot (or bell)seal just below the tub and above the transmission. How do I do it? Do I... [Read more]

1

no heat in dryer, hoover nextra?

can anyone please advise?

1

Zannussi turbodry 1050 - how to clean filter?

I have a zanussi turbodry 1050 and have cleared the filter before; but I have forgotten how to get the round c... [Read more]

1

how to fit a door seal to my hotpoint ultima 1200?

how to get into the old seal?

1

hotpoint wm75 no hot water , changed the element but still no joy?

hotpoint wm75p no hot water, changed the element but still no hot water,