Mend > Home Alarm Systems

1

Hammer symbol on red??

I removed a carpet which had an alarm cable underneath I did nothing to the cable but the alarm went off now t... [Read more]

1

Scantronic 9651 Tamper Zones 01 to 08?

Scantronic 9651 Tamper Zones 01 to 08 is now showing on my display after changing battery, last time this happ... [Read more]

1

Our alarm has a message come up on it “ check low batt” Where is the batter?

Does any one know where the battery is, we’ve looked everywhere. Thankyou

3

Key pad 9827 with control panel 9800 suddenly went off showing bF?

My key pad 9827 with control panel 9800 suddenly went off while I was indoors and it had not been set. It show... [Read more]

C&K 236 Keypad Ping Frequency?

How do I change the ping frequency to the central office to test daily instead of monthly as it is now? I do ... [Read more]

Scantronics 4600?

I have a faulty 04604uk55 contacts board. Any ideas where I can source part or totally eliminate zone 4

Home alarm keeps going off when it’s on thru the night ?

When the alarm is on it keeps going on an off waking up the neighbours

Alarm sounding and showing tamper?

Alarm sounding and showing tamper. How can i solve this problem please?

Alarm sounding and showing r1 h?

What could be wrong and how can I stop it.

Can I purchase mag door entry logic 4?

Require door mag switch ? For Logic 4 intruder system wired

Optima XM house alarm?

Tapper light on unable to reset.Key pad dead What I have done :- Repaced The Battery Tried to reset it . ... [Read more]

1

Reset a newly installed replacement key pad? 9827 ?

please can you help!!! Just purchased an old key pad as a replacement. I don't have the old code so how can I ... [Read more]

9448 panel connections Peronist delta ?

I have a scantonix 9448 panel and ther bell box has failed I’m trying to replace with a PYRONIX DELTA bel bo... [Read more]

1

How can I fix my Veritas 8 Alarm ?

periodically the key pad sticks and the alarm goes off or I cannot set it

2

How can I remove the scantronic keypad in order to plaster behind it?

Having my garage converted and need to remove my scantronic entry/exit key pad in order to plasterboard and pl... [Read more]

2

My Scantonic 9247/9889 simply stopped arming when code was entered?

We can't set our Scantronic alarm. We found the battery dead and one of the three internal fuses blown. We rep... [Read more]

Micromark mm 23092?

I have just purchased the above alarm system and find that the instructions vary from the produce. The leafle... [Read more]

Veritas 8c ?

I have a faulty keypad I think as I can not use buttons 4567890. They do not beep and i now can not set or res... [Read more]

1

how we can we reset without the code?

We have a c and k securitech alarm system ST800L+ which we have never used as we moved in 4 years ago and didn... [Read more]

2

factory reset?

Hello, having trouble getting factory reset on veritas 8, done everything the manual said and it will not fact... [Read more]