Recent: Home max fs506x?

Mend > Dishwashers

Mend ZANUSSI ZSF6152 Dishwasher Fault Sensor

ZANUSSI ZSF6152 Anti flood device?

on start up, pump runs and empties m/c then warning lights flash indicating anti flood device has activated, m/c then stops ? sounds like a water level sensor is stuck in the high position, but cannot locate it, any ideas. ?

Dave
September 2007
the anti flood device kicks in if water is in the bottom of the dishwasher this stops it working as there is a float in the bottom that triggers a switch to tell the machine to stop working.

try tipping the washer back ove this will get the water ou so make sure you have a towel at hand.

the machine should work again if it does stop again then you have a leak.
check the pipe inside the dishwaer at the top right hand side this sometimes comes loose.

or take side panel off run program and check for leaks.

scot
September 2007

Automatic Answer

We may have found other answers which could help you.

Click here for Dishwasher Fault Sensor

Related Questions ...

Mend dishwasher error code repair
1

Aeg Favorit sensor logic dishwasher?

Hi my dishwasher has stopped working and is flashing error code open the tap could anyone advise as to what th... [Read more]
Mend dishwasher fault stuck
4

Fisher and paykel 920 dishwasher has F4 fault and gets stuck at 33 min?

I have a fisher and Paykel dishwasher model 920, It gets stuck at 33 minutes left and then eventually gets the... [Read more]
Mend dishwasher sensor repair
1

temp fault?

NTC (temperature sensor) fault on my Bosch dishwasher so it wont stop washing and wont drain either--how do we... [Read more]
Mend dishwasher stuck sensor
1

My dishwasher is stuck mid-cycle what can I do?

My problem is similar except I have the DW5410 when I reset the machine after checking all pipes were clear an... [Read more]
Mend drains fill water
1

nemo dishwasher dw681es?

drains on startup then when trying to fill 2 lights flash and water solenoid clicks on and off,will fill!but I... [Read more]
Mend power button lights
2

My AEG Favorit 80800 will not switch on what could be the problem?

My AEG Favorit 80800 will not switch on. When the power button is pressed nothing happens, no lights are lit a... [Read more]
Mend fisher paykel nautilus dishwasher
1

Fisher and Paykel nautilus 920 dishwasher displays a F1 AFTER fix?

Fisher and Paykel nautilus 920 dishwasher displays a F1 fault. The control consol circuit board has just been... [Read more]
Mend dishwasher sensor pump
3

Dishwasher fails to complete cycle?

My NEFF dishwasher (S4133F)GB/a14 keeps stopping during the cycle, it doesn't always stop at the same point. ... [Read more]
Mend miele dishwasher f14
9

Miele G1270 dishwasher fault code F14?

My Miele dishwasher (model G 1270) won't start. We've loaded it and put it on "Sensor wash". It makes some n... [Read more]
Mend dishwasher fault sensor
2

How can I fix my Whirlpool ADP 9620 Dishwasher?

The dishwasher does not go right through its cycle. Sometime during the drying cycle it 'detects a fault' and ... [Read more]

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Dishwashers ...