kenmore washer wont spin 80 series model#110.23812100?

its very likley the timer. Run on Permanent Press to see if it works fine and if so, its definitely the timer.

Rob
October 2013

Your transmission is going out and when it runs out of oil it will ruin and have to be replaced. We had ours replaced and it still leaks oil and it is going out again. This model sucks and I won't by another Kenmore.

Irvin Hale
March 2011

wont fill

jamie brown
August 2009

I have the same problem with mine. Clothes are still soaking wet at end of spin cycle. Repairman said needs basket drive,but it's not cost effective to repair. Will need to buy new wahser. Must be common problem with this model.

Claire
June 2009

I had the same problem...lifted the control panel off and checked the timer connections...whatever I wiggled made the washer work again. I am guessing at least my problem is the timer. Since it does fill with water, etc. My daughter had overloaded the washer when it quit...so it could have also been a strain on something (maybe even jammed the shaft). It didn't start working again though until I pulled the panel off. It was making a humming noise. which quit for now, and I have ran 2 loads with no problems...hoping it lasts until I can get a timer.

Alison
December 2008

Im experiencing the same thing on same model, I think its the drive clutch sticking, I dunno

mike
October 2008

I replaced the lid switch and that did not fix the problem. Time for a new washer.

Bro5
October 2008

Try the lid switch.
http://www.repairclinic.com/SmartSearch/SSPartDetail.aspx?PartID=547225&PPStack=1

Michael
February 2008

hello mesha good luk with that.

;alsdkjf
March 2007