Alarm showing all zones faulty?

Your battery is ten years old - it should be replaced ideally every 4 or 5 years. Did you remove or link out the tamper? It may be that + ve from the detection circuit is getting onto the tamper circuit. Check for short between detection and tamper circuit.

Brian
November 2016

you are nothing but an ignorant person,and a troll,go fornicate elsewhere (look it up ) !!!!!

gts
November 2016

Pleb

Pete
November 2016

it did by telling you zones are faulty

gts
November 2016

as i said

gts
November 2016

Linking out the tamper has enabled me to now set the alarm so I just need to find the break (probably to do with fitting the new sensor) but also as to why "Global tamper" did not show.

Pete
November 2016

Hi, the door and frame was replaced so I fitted a new sensor in the frame and soldered pre marked wires. Nothing else was changed. code 99 - checking system, brings up "Zone Flt 01, 02, 03 etc." Code 97 is o.k., code 21 is set correctly, code 199 is 0 ohms on all zones. Removed replacement sensor from panel, still showing zone faults on remainder. Tried shorting "kick start" pins which re-set user code to default. Removed "anti tamper cct." - no change. Carried out a full re-programming after code 98 ( have not tried shorting NVM pins on the board though)
I installed the alarm in 2006 with no PIR's, the battery is original and shows 12.8V. The original pcb was faulty from new so a replacement was fitted (9651EN-00) which is slightly different from the one shown on page 10 of the installation manual.
Codes 48,49,56,58,59,134,135,137,138,140 plus others, are not available which I put down to it being a different version.

Pete
November 2016

have you checked the wiring in door contact ?who was messing about with the panel ?

gts
November 2016