Mend Accenta 6 Home Alarm Systems

Mend Security Systems, Home Alarm Systems

Find out how to mend it for free.

Ask Question

Find out how to mend Accenta 6 home alarm systems

Mend home alarm systems ...

Mend Home Alarm Systems

Mend > Home Alarm Systems

Mend Accenta 6 Bell Box Alarm Going Years

How can i change the outside bell box without alarm going off?

I have an accenta 6 alarm which has worked well for years. The other day I had the alarm on whilst watching tv and opened a door which set the alarm off. I assume a fuse blew because I could not enter the code to stop it so had to go up ladder and open bell box and snip the wires until it stopped. I noticed the bell box was a bit shabby looking so now i have the alarm all working properly again i would like to change the bell box but even when in engineering mode the alarm goes off when i open the bell box lid?

Peter.
December 2006

Accenta 6 Security Systems, Home Alarm Systems Bell Box Alarm Going Years

Ashley,
Thanks very much for that reply. Very, very useful.

Peter.
December 2006

The sounder will always ring when opened wether it is in engineers mode or not, because of the tamper feature, however there should be inside the sounder a series of metal prongs with numbers next to them the shortest normally being around 5 seconds simply short these pins out and the sounder will fall silent. thus enabling you to change the sounder without upsetting the neighbours to much, please bear in mind when installing the new sounder that they are only allowed to sound for a maximum of 20 minutes at a time,whilst there are no regulations for the strobe light, once the sounder is changed simply enter your code as if you were setting the alarm and then re enter the tamper light will go out and then will be ready to use please note when doing this the control panel should be in engineers mode.

ashley
December 2006