Recent: Safely remove screen protector from a Macbook Air?

Mend > Computer Hardware

Mend Barcrest Elvis Top 20 Machine Test

barcrest elvis top 20 wont boot up?

Machine crashed during play, and went to self test screen. Wont boot from power up now either.
Top display says self test (RED GREEN BLUE SQUARES) "This monitor is working. Check cable and computer"
Lower screen: "No signal"
Tried rebooting several times, but same happening.

jeremy postlethwaite
October 2012
Your monitor is working OK but get no signal from the computer.

Does the fan(s) at least start to work?
If the fans don't even start to spin, your power supply is probably bad and need to be replaced. Get a new one of about the same power rating as your actual one.

Do you hear any beep sound when you try to boot?
If no beep at all, the computer is dead.
You need to replace the computer. Any drive is still good and can be mounted in the new computer if you get a desktop model.

Is it a single beep or several? Any dicernable pattern in the beeps? Some computers use LED codes. Normaly, they will flash briefly and go off or leave only the num lock one on. Any other pattern is an error indicator.
A single beep means a normal situation.

Your video card may have a problem, or you may have faulty RAM or some other problem.

In the first case you may have an unseated or dead card. Try removing the card and replacing it. If you still have no display, get a new card.

It may be a RAM problem or the memory moduls could be unseated.
In turn, remove each memory moduls and replace them in the same location.
If you still have problems, replace the memory (RAM). Take the ocasion to upgrade it to the largest amount you can.

If it's the motherboard, the CPU or some other component, it will be about impossible to correct and you'll need to replace the computer. The drive(s) should be OK.

Electro
October 2012

Automatic Answer

We may have found other answers which could help you.

Click here for Top Machine Test

Related Questions ...

Mend washing machine drain pump diagnostic
1

My Fisher & Paykel GWL15-96155B won't pump the water out just back into tub?

Follow up to my previous post: I looked into this again today. The machine will fill the tub with water, the t... [Read more]
Mend drying aeg machine
1

Not drying correctly AEG Lavatherm 37320 Electronic vented tumble dryer?

Machine operation seems normal but not drying correctly even after long period of operation. It has good warm... [Read more]
Mend front years coming
3

how to fix electrolux ew1080f?

hi, my electrolux front loader ew1080f (about 5 years old) machine keeps stopping during operation and has be... [Read more]
Mend dry properly drying
3

AEG 18630 Washer/Dryer won't dry properly?

The drying cycle had been exhibiting "Zanussi Time", counting down too fast and leaving the clothes cool and w... [Read more]
Mend flashing eco dishwasher described
2

Hotpoint DWM55 Error - Flashing Lights Eco and Fast?

My dishwasher recently gave me the flashing lights as described in the Title of this thread. I contacted Hotpo... [Read more]
Mend washing machine appliance repair
2

HOOVER 1300 EASY LOGIC AA WASHING MACHINE?

HOOVER 1300 EASY LOGIC AA WASHING MACHINE STOPPED MID SPIN CYCLE NO STANDBY LIGHT ON NOW BUT THERE SEEMS TO B... [Read more]
Mend dishwasher repair pump
1

AEG Dishwasher - Sludge in water inlet matrix - how to clean?

AEG Dishwasher - Sludge in water inlet matrix - how to clean? Model: AEG OKO Favorit 5040 dishwasher Ques... [Read more]
Mend dishwasher pump repair
2

AEG Dishwasher - Not emptying - how to remove and test pump?

Model: AEG OKO Favorit 5040 dishwasher Question: Any suggestions on how best to remove and test the small em... [Read more]
Mend washing machine drain pump blocked hose
1

Whirlpool AWM 049 not draining?

Stops mid-cycle and won't drain. I've taken the pump off and tested it, and it spins fine, impeller spins fine... [Read more]
Mend washing machine motor whirlpool
1

how can I test run washing machine motor?

How can I test run my old Whirlpool top loader motor on workbench ie how to connect it manually. Motor : fsp ... [Read more]
Mend indesit washing machine
3

What is causing the belt to slip on an Indesit we125 washing machine?

The drive belt on my Indesit we125 washing machine slipped off the large wheel attached to the drum, causing t... [Read more]
Mend replace switch wash
1

How to replace lid switch or its fuse to Maytag MAV6200AWW top loading wash?

Could someone please tell me if the lid switch to my Maytag Serial # 20119968ZH toploading washer contains a 1... [Read more]
Mend washing machine motor brushes drum
1

Hotpoint Aqarius won't spin despite new brushes?

My Hotpoint Aqarius washer/drier had been working ok but then just stopped spinning. I have run a test cycle a... [Read more]
Mend bevel gear singer
1

How can I fix small bevel nylon gear on Singer 478?

I just serviced my Singer 478 sewing machine and put newer heavier thread into machine to mend denim. It worke... [Read more]
Mend washing machine agitator filter
1

simpson aquarius 806 - what size nut inside rotator thing?

Inside the washbowl of my washing machine is that 'rotator' (if that's the right word) or perhaps 'agitator'. ... [Read more]

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Computer Hardware ...