Recent: Safely remove screen protector from a Macbook Air?

Mend > Cars

Mend Peugeot 307 Mode Battery Change

307 1.6 petrol 2002 limp mode after battery change!?

My 307 has a fault saying Anti pollution fault and engine management light is on. car starts ok, but has no power, it wont rev past 1500 revs. All i did was replace flat battery. Can I reset this fault?

david
December 2011
See

http://www.benzworld.org/forums/w202-c36-amg-c43-amg/1452724-limp-home-mode-after-battery-replacement.html

I know yours isn't a Merc but it has got to be worth a try?

ChicksFan
December 2011
You could try this.
Get in the car, turn the ignition on. Leave it on for 10 seconds. Turn the ignition off, leave it for 10 seconds and then remove the key.
That may reset it.

Good luck.

ChicksFan
December 2011
The engine computer will of registered the low battery voltage and put it into protection mode, you will have to get the codes read with a diagnostic reader and reset, £20 from an independant garage.

nigel
December 2011
Did you replace it with a brand new fully charged battery?

ChicksFan
December 2011

Related Questions ...

Mend security alarm system
4

bell box battery change and service?

hi there i got a bit of a problem with my prima 500 bellbox, i am trying to change the battery but every time ... [Read more]
Mend tamper pir keypad
15

Accenta G4 mini and remote keypad only illuminating?

I recently had an issue with my Accenta G4 alarm and remote keypad. For some unknown reason the tampers were a... [Read more]
Mend security system code
4

how can i change the pin number?

i have a micromark z9495a alarm fitted to my property. i need to change the pin as the previous owners dont kn... [Read more]
Mend alarm system battery reset
1

Optima XM6 alarm system battery change?

Not an engineer, and instructions not clear so could anyone tell me how to fit new battery. Do you press PROG,... [Read more]
Mend car radio radio code vauxhall astra
1

Philips Car 400 Radio Code?

Hi/Help! - After a Battery change on my Vauxhall Astra, the radio has gone into "safe" mode. I was given a 4 ... [Read more]
Mend itec horizon alarm
1

Itec horizon alarm panel?

With my limited knowledge, I put in engineers code 1191 to open control panel to change battery. This worked o... [Read more]
Mend turning power work
2

Accenta Alarm G3 wont alarm after turning power off?

Hi there.. might be coincidental however our Accenta G3 alarm wont seem to alarm now after we turned the power... [Read more]
Mend power failure battery
1

how do i get my Vitiras R8 into programming mode?

Hi can anybody assist we had a power failure and my system went into battery backup which totally drained the ... [Read more]
Mend power inside toshiba
2

faulty power supply inside Toshiba laptop?

Got a Toshiba sp6100 model: ps610e-03skv-en the problem is there some sort of power supply fault with the main... [Read more]

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Cars ...