Mend > Home Alarm Systems

Mend Scantronic 9800+ Keypad System Fault

Hi men, I have a scantronic 9800+ system ?

Some time ago in this area we had a lightening strike which fried the phones in the house and allso since then the remote
key pads of the alarm have no LED"s showing anywhere, totally blank. I therefore cannot get into the system to reprogramme it or to see what if any fault codes are showing. There appears to be power to the remote keypads as the keys are backlit when I attempt to enter any codes, but nothing happens apart from sounds from the pad when the numbers are pressed. Any help would be appreciated,
Thanks in atticipation

Dec
November 2011

Scantronic Scantronic 9800+Security Systems, Home Alarm Systems Keypad System Fault

scroll down

gts
December 2011

I have not recieved the advice apparently posted by Acorn for some reason ??? how can I get in touch with him???

As regards the question from gts, No it is not a monitored
alarm and as far as I know is not connected to the telephone system either.

Regards dec

Dec
December 2011

get back to acorn if his plan works,

gts
November 2011

thats connected to your phone line,(case u not know)if it is, the panel be may be blown,(the lightening arresters in phone socket dont work(that has been our experience)but try acorn suggestion,you may be lucky
hope you are,and you are one of the smarter guys,you buy a very good panel,unlike most

gts
November 2011

is it a monitored system?

gts
November 2011

Turn off the mains, remove the battery, close the panel, switch the mains back on, see what happens. If it seems to come back to life and the keys start working again, get a new battery.

If none of the above works .....................

acorn
November 2011

Mend > Home Alarm Systems

Hi men, I have a scantronic 9800+ system ?

Hi men, I have a scantronic 9800+ system ?

I can answer this question ...

Hi men, I have a scantronic 9800+ system ?

Related Questions ...

I have a problem with my house alarm system SYSTEM: EUROSEC?

How to fix my Texecom Veritas Home Alarm Power issue?

Honeywell Accenta Gen 4 - LCD Keypad - Power Light but not responding?

Blank remote keypad?

how to fix scantronic 9751 K01 Tamper reset?

Bosch ICP series intruder alarm?

Scantronic 9800 - c1 alternating t1 (Temper Fault)?

Scantronic I-on 16 batt Low?

Why is Accenta G4 LCD keypad unreadable after blown fuse?

Tamper lockout...how to fix it?

Optima XM6 alarm system?

honeywell g4 ?

I have a fault on my system?

veritas R8 - gone off, tamper light on, code not accepted......HELP!!!!?

ADT 3200 House Alarm?

How to mend ...

Other models...

Related Categories

Topic