In reassembling the two bearings and seal onto the drive shaft for the drum on a Tricity Bendix washer dryer model CWD 1000, what is the correct position of the seal over the brass bush? Where should the grease be applied to the seal? To the concave inner surface against the bush and or on front and back of the seal? Advice and info would be gratefully received.
Thanks
Roy
Seal should be over the brass piece.make sure brass is clean and smooth or it will destroy the new seal within weeks.Grease goes in the concave bit of the seal but i usually put grease on the face of the inner bearing before fitting the seal as well