I have a cooper 9751 with a telecommand 722r remote fob. The battery on the fob failed so the alarm panel gave the message "telecmd low bat" I have replaced the battery and the remote fob now works and I can set and unset the system fine. However the fault light on the control panel is still lit. I have tried another battery and still the fob works but the control panel wont stop shoing a fault. I have tried to clear the fault by entering the user code and then pressing 1 followed by the tick and the cross buttons but nothing seems to clear the warning. I cannot set the alarm on the crontrol pannel but as I say the fob works fine.
Thanks for the advice. I had already tried to clear the messages using the option 1 tick tick. but to no success as its still reporting a fault even through the alarm works fine from the fob. The message even says inactive but wont clear. I would be tempted to switch the system off and on but not sure if this would clear everything.
David G
November 2010
you got it ,pity he hasent
gts
October 2010
Something like stop using the %%%%%### fob and set via the keypad.
Perhaps :P
Alarm
October 2010
i give up alarm guy,its so obvious
gts
October 2010
Sounds like the EN panel you have to acknowledge the fault not just try and set it.
Press code 1 tick tick tick until all the alerts go if not its seeing the battery as a system fault and you need an engineer.
howtomendit.com for free repair help, information and advice.
Try fixfault.com to fix home alarm systems.