5 hours ago: No lights and water in bottom of machine?

Mend Glow Worm 100e Home Heating Systems

Mend Heating, Home Heating Systems
Find out how to mend it for free.
Ask Question
Mend Heating, Home Heating Systems
Find out how to mend Glow Worm 100e home heating systems

Mend Home Heating Systems

Mend radiator thermostatic stuck
1

One radiator in a bedroom is always cold?

One radiator in a bedroom is always cold. It used to work fine. I have tested the thermostatic value and the... [Read more]
Mend sabre pressure water

Sabre 29 water pressure drop?

sabre 29 water pressure dropped, how to increase the pressure
Mend boiler greenstar cdi heating

Worcester Greenstar CDi boiler won't fire up the central-h?

flashing green light near the CH select button new batteries in transmitter
Mend Heating, Home Heating Systems
1

How do i stop the time from flashing on the Siemens RDJ100RF?

How do i stop the time from flashing on the Siemens RDJ100RF unit
Mend Heating, Home Heating Systems

Flamerite Isis Fire?

i need a new mother board for my flamerite isis fire do you know where i can purchase one
Mend Home Heating Systems

Mend > Home Heating Systems

Mend Glow Worm 100e Hot Time

Hot water comming out cold - Glow Worm 100e?

Water runs hot (very hot) for a short time, then flame goes out. Few seconds later it fires up but then trips out (red LED). Managed to turn down temperature control dial to about half way, the water comes out HOT, but doesn't trip out. If I turn the temp up then it trips out again.

Sounds like it is overheating but why?

CrowDA
April 2006
Glow WormGlow Worm 100eHeating, Home Heating SystemsHot Worm Time
Thanks Bob. Can you tell me which diphram you are refering to. Perhaps it is best I strip the lot!!!
I find that if I turn the temp down and then run the hot water slowly then it maintains.

Funny thing is that the central heating works fine.

CrowDA
April 2006
the diaphram is letting by (renew it)
and check the h/w/heat exchanger is not clogged up.
last one i did, I found sand and stones in it, from pipework not being protected during installation, the other problem is rust from your rads,causing flakes to block the h/w/exchanger

bob the plumb
April 2006

Automatic Answer

We may have found other answers which could help you.

Click here for Hot Worm Time
Mend fault code ignition heating

loud bang when boiler fires up, fault code F1 if it fails to fire?
Mend boiler pump pipes

Why is my upstairs heating always on?
Mend thermostat heating boiler

Replacing LP112 Programmer?
Mend boiler lockout fan

how can I fix my Micron 80FF Glow Worm Boiler?
Mend heating boiler thermostat

why is radiators hot when only water is on..HELP?
Mend heating boiler troubleshooting

Why are my radiators are not heating?
Mend heating pilot light thermostat

Glow worm 45/60 not firing up?
Mend central heating boiler months ago

how can I fix my old glow worm central heating boiler model 65-80?
Mend heating radiators fault

Glow Worm Fuel Saver F not working properly ?
Mend boiler ignition gas engineer

What does F43 error message mean on Glow Worm 24/30cx?
Mend boiler heating glowworm

boiler internal fuse keep blowing out!?
Mend burner hot water help

Glow worm 100E small burner flame, now hot water?

Other models...

Glow Worm 18hxiGlow Worm 30 CXIGlow Worm 30ciGlow Worm 30CXIGlow Worm Swift Flow 80Glow Worm Ultimate

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Home Heating Systems ...

Related Categories

Mend Convector Heaters
Convector Heaters
Mend Fan Heaters
Fan Heaters
Mend Oil Filled Radiators
Oil Filled Radiators

Mend Heating, Home Heating Systems
Find out how to mend Glow Worm 100e home heating systems