fisher and paykel gwl11?

The start of all my problems is with weak spin and water on the floor after final spin.I took diverter off and found plastic from rim inside. I cleaned it out and put it back on. I put a wash on and it went through the wash but then started to beep as though it was off balance. I pushed the start button and it continued through rinse cycle and started to beep again and when I opened the lid it had not rinsed the detergent out but it did drain. I pushed the start again but this time it would not continue.
I then disconected the wires off the diverter and restarted wash on the permanant press setting as to not have to use the diverter and should complete the wash, rinse and spin. On this setting it did complete the full cycle with one problem it did not rinse the detergent out. Could I have put the diverter on the wrong way? Or does my control board need to be put to rest?