modena 102 combi flame failure?

Cleaned safety overheat and CH flow limit thermostats (much chalk like material on them) also repaired room seal on cover, put all back and working fine since

chizy1
April 2009

Ah well this is ignition lockout. Intermittant ignition lockout is a pain in the arse at the best of times! because the fault isn't showing itself very often, it's very difficult to trace. It could be lots of things. i'd check all gas pressures are correct and check electrodes/leads. after these checks, it may just be best endevour. personally, i'd wait till the fault gets worse so it's easier to trace. a little awkward, but it beats replacing costly parts blindly.

andy gas man
April 2009

The red light is solid and yes it resets OK

chizy1
April 2009

It's a bit vague to just say the flame fails. have you got any further info? like what are the lights on the front of the boiler doing when the boiler is at fault. is there a red light flashing? or is the red light solid? etc.... The temp sensors are prone to failing and causing intermittant faults. If the boiler resets ok after it fails there's probably no point testing the sensors themselves so i'd just change them. They are about £17 each and you'll need two of them. hope that helps!

andy gas man
April 2009