scantronic 9448+ code?

*** IF IN DOUBT DO NOT FOLLOW THIS INSTRUCT ***
*** IF IN DOUBT CONTACT AN INSTALLATION COMPANY ***

The default user code is 1234
The default engineer code is 7890

You can easily default the system memory to factory defaults but you will also need an installation guide to reprogram.

To default (all programming to factory defaults):
1. Power down control panel - Mains & Battery
2. Locate Pins on motherboard marked 'RST'
3. Shirt 'RST' pins together - use a small screwdriver
4. Power system up (Mains) with RST pins still shorted, wait 5 seconds then remove the short (screwdriver). Connect your battery.

Dalamier
May 2009

try ukpanels.com

roy
January 2009