HELP WITH EUROVOX PLZ?

hi mick thanks again i've done the symbol rate like u said and all the channels are comin back on the screen but no picture and i dont know the codes for it and also would need instructions how to put new codes in plz.thanks

khan
December 2008

sorry , 6887 symbol rate for ntl , and 6852 for tellywest i think

mick
December 2008

thats should be (START 100 mzh) (STOP 870mzh), and the symbol rate , 6952 , or 6997 , , but try 6952 , first , and then do the powerscann , but rember that if your codes are not up to date, you wont get any channells

mick
December 2008

yes i can see it and the start symbol rate is 100.00mhz and the stop is 870.00,thanks mick

khan
December 2008

when you get into the(user installation) box" press the yellow button" and a new box opens up , at the top of it it will say ( full power scann) and in that box you should see ,( start ) (stop) sylmbol rate " ect? tell me can you see that box ?

mick
December 2008

thanks mick im with telewest virgin,i've put in 0000 after user installation and its just a blank page here,only a red quality signal moving and when i try auto scan it says no transponder to scan.i think i've deleted data or something,can u help mick plz,thanks

khan
December 2008

first of all , who is your cable provider / ntl / tellywest virgin / ect , check this out first, go to menu, then (installation ) then (user installation ) ok that " pin number is 0000 , look for (symbol rate) in that page " if your useing ntl , it should be 6887, if its differen number there , make it 6887 with your remote , for ntl , and rescann , ill check back here tomorrow, mick....

mick
December 2008

That was a silly thing to do!

Boroboy
December 2008