zanussi nexia fl884 not spinning?

some of these models had induction motors (brushless motor).they had a large capacitor mounted under the top lid and these became weak and would only do a small load spin because they need to be replaced.genuine part is about £20 in uk.

ck
November 2008

Check out the carbon brushes in the motor. Theyre graphite blocks which transfer mains power to the copper segments of the motor -Theyre probably worn down. They're quite cheap parts and easy to replace. Power off, remove the back cover and locate the motor. May help if the machine is tilted at an angle or laid on its side. The brushes are at the other end of the motor from the drive pulley. The holders are plastic or bakelite and are generally held in with screws or plastic clips. Also, look at the copper segments they run on to check for burning or pitting. If the segments are burnt or damaged you need a replacement motor or a replacement armature (motor part) if you can source one. Occasionally may be a fault in the motor drive circuit board - in which case replacement of board only real option.

Repair and service your own washing machine. Go to www.2ndwave.co.uk/manual.html

dannyboy
November 2008