My Aquarius WM76 flipped a fuse switch?

E30 - motor drive problem.
Check out the carbon brushes in the motor. Theyre graphite blocks which transfer mains power to the copper segments of the motor - located at the other end of the motor from the drive pulley. Theyre probably worn down. They're quite cheap parts and easy to replace - the holders are plastic or bakelite and are generally held in with screws or plastic clips. Also, look at the copper segments they run on to check for burning or pitting. If the segments are burnt or damaged you need a replacement motor or a replacement armature (motor part) if you can source one. Occasionally may be a fault in the motor drive circuit board - in which case replacement of board only real option. Check the wires in the motor plug - these are notorious for breaking internally so give each one a tug. The older Hotpoint models had a motor choke with a pink and gray wire connecting it to the motor; if you have one of these the pink wire is normally the culprit. The timer can cause problems of this type, check for burnt connections or of course it could be an internal break in the motor itself which would require replacement of the motor.

Repair and service your own washing machine. Go to www.2ndwave.co.uk/manual.html

dannyboy
October 2008