How do i lock the crankshaft?

under injection pump near rear of pump there will be a hole or tork bolt to remove which give you room to place an 8mm drill bit, make sure you dont go into flywheel balance holes you should be able to line up camshaft marks to make sure you are in the right place, hope this helps

chris h
July 2008

Will have to remove flywheel cover and hold flywheel in place if you don`t have impact ......have also seen people use a breaker bar with socket on bolt and position breaker bar in away so it doesn`t hit anything and lay it in frame ect and bump starter to losen the bolt ....make sure engine turns in right direction for loosenin the bolt

bg
July 2008