Recent: Home max fs506x?

Mend > Powerboats

Mend Yamaha Waveventure Running Test Water

1995 Yamaha Waveventure quit running?

I just bought this and took it out for a test run, it hadn't been in the water for over a year, it ran fine for about a 1/2 hour (Top speed 51 MPH) then all of a sudden it lost power, engine quit, re-started but wouldn't go over 6 MPH, half throttle, full throttle, it didn't matter RPM's wouldn't come up, then after about 5 mins I was back to full power, it ran fine for about 15 mins then quit again, this time it wouldn't re-start, engine just spins over...So I got a tow back to the dock & started running some basic checks, Plugs were dry, light brown/tan apearance,
Had good spark, seemed to have good compression, fuel filter was still full. When the engine quit it felt like it ran out of fuel, even though the fuel filter was full, could the fuel pump have failed? Any sugestions on where to start checking? This is a 700cc engine....Thanks, T.J.

TJ
June 2008
never put any kinda fuel injection cleaner in ure gas tank i did it n it caused a chemical reaction mixing with da two cycle oil that u put in it . will make a gummy substance be in ure fuel tank n it cud get in ure carb causing u to keep stalling out .

scott
March 2013
I just finished repairing a WVT700T with similar problems. Old gas, get it out. Put fresh plugs and about 5 gal. gas with 8 oz. Seafoam carb cleaner and run it until it runs out of gas. If it works you will have WOT speed just as you get to the reserve level. I actually ran 12 gal. with Seafoam just to be sure and it is running like new. It cleaned out the jets. But... with my XL1200 the problem with similar symptoms was clogged hoses - sand in the exhaust system. If this is your problem the symptom shows up as a split hose leaving the exhaust manifold just after the firewall. The exhaust gases are too hot. Then disassemble the exhaust manifold and clear out the jackets and all the small hoses. Good Luck.

JEK58
July 2009
Our Yamaha Waveventure did the same thing. We had all of the fuel drained and found water in the bottom of the tank. Fresh gas was put in and a brand new battery was installed. Even though we had a year old battery, the mechanic said it was not the commercial type needed for the Yamaha. We were also over filling the oil. It runs great now. You may need to one or all of these things.

ch from Madison, MS
March 2009
i have a 1997 yamaha wave venture. samer thing happened to miine. it was the fuel switch. it failed and i put a new one in and it works gereat now. the fuel switch is the with the reserve, on and off...change it it onlys $15

scotia17@gmail.copm
January 2009
We have been chasing this issue for years. I found the solution one day by accident during some routine checking of systems. Under the main seat, at the rear of the engine is a black electrical box. Inside the box, is a fuse holder. The fuse holder has started to lose connection between the fuse and holder, thus the loss of engine function. The heat is based on the expansion of the fuse holder when the engine compartment comes up to temperature.

This has happened several times. While you are floating, just lift up the seat pull the fuse, blown in the holder, and reassembly. It will get you running, ...but do not forget to replace the fuse holder.

Lewis1
August 2008
Check your fuel quality if you didn't put new fuel in it since it was setting for several months. Check the fuel bowls for gum substance in carb fuel bowls. This gum can clog small orfices in the carb and effect fuel flow.

larry
August 2008
My 95 waverunner did the same thing. The gas got low and all I did was put the reserve on. I felt dumb but that was it.

merilee
July 2008

Related Questions ...

Mend spin washing water
2

Zanussi zwf 14581w not spinning?

Machine failed to spin after washing. Not a lot of water in drum, so I assume pump for draining is o.k,(sounds... [Read more]
Mend 2000 renault scenic
1

new water pump and cambelt kit - but leaking coolant?

2000 renault scenic rt 1.6 16v automatic new water pump and cambelt kit - but leaking coolant the car runs ... [Read more]
Mend boiler leak heating
3

Baxi Combi 133 HE Plus loosing WAY to much pressure?

Hope you can lend some advise, I recently had the above boiler installed and I am only running 4 radiators at ... [Read more]
Mend heating pressure radiators
1

Baxi Combi 133 HE Plus loosing WAY to much pressure?

Hope you can lend some advise, I recently had the above boiler installed and I am only running 4 radiators at ... [Read more]
Mend boiler hot heating switch
1

Ravenheat LS100T combi boiler?

The boiler is not working on either the hot water or the central heating. When I go to switch it on the green ... [Read more]
Mend electric heating fault
1

Neptune Solo 8.5kW won't turn on?

My Neptune Solo 8.5kW has been running normally and yesterday shut off during a shower. There is no neon indi... [Read more]
Mend zanussi checked brushes
1

zanussi washer/dryer?

ck thanks for your reply i have checked the brushes they r more than 10 mm no water or foam went in the pcb al... [Read more]
Mend car cutting gear
1

how can i stop my car from cutting out in low gear?

my 1994 nissan micra has started to hesitate when driving at normal speeds and the engine cuts out intermittan... [Read more]
Mend blown 2002 ford
1

BLOWN HEAD GASKET ON 2002 TRANSIT 2.4 DURATORQ?

HAVE OVERHEATING PROBLEMS ON MY 2002 FORD TRANSIT JUMBO 2.4 DURATORQ (125PS)DONE 56,000 MILES WAS OVERHEATI... [Read more]
Mend boiler fires seconds
9

FERROLI OPTIMAX 25C OVERHEATING?

When I turn on the hot tap the boiler fires up then a few seconds later it overheats and I get F3 fault code, ... [Read more]
Mend boiler heating system gas
1

main medway hot water boiler?

my pilot light on my boiler stay lit until i turn the tap on and then after a few seconds of running it all go... [Read more]
Mend ariston heater cycle
1

ariston A1626 heater element?

hi hope someone can help my ariston was running fine until it started making a grinding inside the drum so bei... [Read more]
Mend zanussi program drain
1

zanussi z818 not stopping on fill, how to fix?

HELP! my zanussi z818 is not stopping filling with water on any of the program selections. It will drain ok if... [Read more]
Mend boiler radiators central heating
1

Central heating does not reach all radiators?

Profile potterton boiler 60e.We have 8 radiators +1 towel rail fitted in our house.The problem is when heating... [Read more]
Mend boiler heating fault
2

Heating Fault - Pump continually runs (Maxol microturbo 402)?

I have a Maxol microturbo 402 domestic boiler that is used for the central heating and hot water in my home. T... [Read more]

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Powerboats ...

Related Categories

Mend Yachts
Yachts