Flashing light indicates a functional problem. Since writing is worn off you'll have to go thru this checklist:
Poss. heater fault - Power off, remove back cover. Heater is located at bottom of drum. Disconnect wiring, undo central mounting nut and prise it out of its rubber seal - may require some effort.If replacing a faulty heater, use sealant when refitting rubber seal.
possible pressure switch fault - Check the pressure switch - a round item about 3 inches across with several wires connected, it sits under the top cover. Its an air operated switch which tells the machine water has reached the correct level. Disconnect the thin rubber pipe from the switch and blow down through it to clear any blockage. Switch itself may be faulty but its more likely the pipe is blocked.
Also check the filter - generally located behind a panel at the foot of the machine.Some are obvious like little square hatches and some are hidden behind the trim panel at the foot of the machine. Once panel is removed the filter will be seen. Its a circular fitting which generally unscrews in an anticlockwise direction.
Some filters are pretty well disguised by the manufacturers which is a big help to their customers and some machines have no filters at all which allows all manner of debris and detritus directly into the pump.
possible motor fault - Check out the carbon brushes in the motor. Theyre graphite blocks which transfer mains power to the copper segments of the motor - located at the other end of the motor from the drive pulley. Theyre probably worn down. They're quite cheap parts and easy to replace - the holders are plastic or bakelite and are generally held in with screws or plastic clips. Also, look at the copper segments they run on to check for burning or pitting. If the segments are burnt or damaged you need a replacement motor or a replacement armature (motor part) if you can source one. Occasionally may be a fault in the motor drive circuit board - in which case replacement of board only real option.
Check that the pump is working and isnt blocked internally. Replace if faulty.
Possibly a duff connection on one of the board connectors? Power off, remove covers, disconnect circuit board connectors and clean with toothbrush. May help to tighten them with a pair of pliers. Clean off any corrosion or crud, refit and test.
And if that doesnt cure it at least you'll have learned something about washing machines....
Check out this site for spares : www.4directelectricals.co.uk
Check out this site for info: www.2ndwave.co.uk/manual.html
dan
February 2008
howtomendit.com for free repair help, information and advice.
