Recent: Fix food processor motor?

Mend Peugeot 406 Cars

Mend Vehicles, Cars
Find out how to mend it for free.

Ask Question
Mend Vehicles, Cars
Click here to mend Peugeot 406 cars

Mend > Cars

Mend Peugeot 406 Anti Pollution Fault

anti pollution fault engine managment?

i have a peugeot 406 hdi. the engine management light comes on and its say anti pollution fault then the car a no power wont rev over 2500 revs. if u pull over turn off the engine and leave it for 2 minutes then start it again the car is ok for maybe 15 20 minutes then the fault comes back on and the engine managment light ive had her plug in & come back with codes p1198 fuel regulator & p1113 Intake air temperature (IAT) sensor circuit open/short any ideas please

stew
January 2008
My 406 Executive, (petrol 2,0 litre) the anti pollution warning has came on.
What is the best advice on what to do to it?

Wil
April 2017
just get a pp2000 scanner to verify the problem.pp2000 peugeot planner 2000 is a scanning device used to establish sensor related problems.its the best way to solve the problem

alhassan z
August 2014
The last time I had this problem I found out that the flexi pipe connecting to the CAT was loose. After it was fixed I hadn't had a problem up until now - a year later!! It's driving me bonkers. Any suggestions on what else could be wrong with the damn thing would be highly appreciated

Suzanne
March 2014
im the same with my 2001 406,,absolute nightmare ,wont go over 3000 revs.when engine dies i switch it off at key (sometimes clutch n free wheelin)and it starts again after ignition or bump starts. problem now is m.o.t fault lights mean fail in n.ireland,anti pollution on all the time+engine management..could e.r.g b the problem?

gary
October 2012
My 406 2.0 engine antipollution problem came on too. And each time that happens, it loses power and can't rev normally. I have tried servicing the engine and it stopped for some minutes and started again. I also dusted the air filter too. Is it a major problem or can it be fixed? I hope I can find some answers soon cos it really hurts, especially in the middle of traffic.

Justin
June 2012
I have a 51 plate 406 Coupe and the Antipollution warning is on all the time. Peugeot garage have reset it and it came on after 3 days - even after the ECU was reset and all previous faults cleared from it. Aparently there is a known problem with non-Bosch spark plugs - but that made no difference. It's goung in again to get a diagnosis from France!

I'll keep you posted. In the meantime I'll change the air filter to see if it helps

Nick Leo
November 2011
I have had the same problem three times now with my 04 Reg 406 but I have not experienced any lack of power. The warning light stays on for a few days and then dissappears. At the moment the warning light is on and has been for two days now. The car is running normally. The last time this happened was during April last year. The warnig stayed for about five days. Since I am not loosing power, I am nor worried about it and I hope the warning light will disappear of it's own accord during the coming week.

Selwyn
January 2011
I have the same problem. It's a 406 HDi. Gear box stucks every now and then. What do I do?

J A
October 2010
My 406 Executive, (petrol 2,0 litre) the anti pollution warning has came on.
What is the best advice on what to do to it?

FrustratedIan
May 2010
peugeot 406 110 hdi gtx engine managment lights keeps coming on and anti pollution on display screen on car

mr nathan hillyeard
May 2009
2001 406 2.0i est petrol (mostly supermarket), same warning, tried without air filter, (foam should be at bottom by the way), no change, went around all visible electrical connectors at top and behind engine, seperated each and squirted with WD40 into plugs then remade, started engine and fault cleared.

Stevie B
May 2009
yes i had the same problem i changed my air filter with one that did not have the foam and the fault came on, then changed it for one with foam and the fault went. strange but that was the problem.

shugo (^_^)
May 2009
cat filter

najd
February 2009
I had this on my 02 plate 406. Read lots and lots of answers but what I did was to replace the air filter. I know it sounds stupid but I did it 6 months ago and have had no probs at all since. What I have noticed is there is a layer of foam on the top of the air filter - which was missing on the one I took out. As I said works a treat and done a further 6000 miles and no light. Try it you never know.

Phil
January 2009
Hi Stew, did you get your car sorted? I've got exactly the same problem and fault codes with my 406. Would very much appreciate any advice. Cheers, Mike.

Mike
October 2008
Mend Vehicles, Cars
Click here to mend Peugeot 406 cars

How to mend ...

Find out how to mend just about anything howtomendit.com for free repair help, information and advice.
Mend Vehicles, Cars
Click here to mend Peugeot 406 cars